Hi,

I'm trying to send sysex from a Max/MSP patch to an AB64, which
basically works. However, I need to send a very long sysex message,
and rough calculations suggest that it would take a minimum of about
3 seconds to send down a midi cable, assuming my maths is correct.

I need to control input on/off and gain, output on/off and gain, plus
gain and delay at each of the 64 cross-points.

I could send via UDP, but have found no info on the implementation.
Obviously (?) UDP is used to communicate between the AB64 and
ABShowMaker. What would happen if UDP comes from a third source ??
Can sysex be sent to the AB64 and ABShowMaker over UDP ?? What are
the port numbers ??

Ciao,

Dave Hunt