Folks, here is a page I just found fyi: http://sound.westhost.com/fake/counterfeit-p3.htm#21193 I just looked through my pile of scrap transistors and found...
If you experience a fairly hot or melting coil this means your transistor is fried. And that is caused by several possible reasons. One is because of using...
hi again,bought 2 new batteries, 12volts, 5ah..test it with the setup,i started to spin then it goes on and the neon bulb lights brightly, then i set the pot...
The neon bulb is not supposed to ever go on. It is there as a safety in case you disconnect the charging battery. The power runs through the neon bulb instead...
hi again to all,ive bought a new analog meter,, im doing the load test,ive made data on the 1st experiment,. test the amp draw,60ma,12volts,battery input,same...
Al, If it was not clear in the instructions, you are to use another pot for that bulb test, not the pot in the SSG circuit. It can be the same. But the idea is...
Hi I just joined and I'm confused about the coil. The schematic shows # 23 and # 26 wire being used but the materials list calls for # 20 and # 23. Also, there...
Hi, I think I might of damage my coil. The motor was working fine. I decided to use some capacitor to discharge into the coil instead of the battery. Obviously...
hi, you can use the schematics or the list, i think its the same, its like a small setup and a big setup.. mine is 20 and 23.. for the length of the wire, you...
Dennis, Sorry about that. You can use either set of wires or many others if you know what you are doing. People may as well go with the cheeper wire which is...
If you blow the transistor majorly you will have this affect. And the coil will humm and get hot real fast. You can ruin a transistor without ruining the coil....
hello again.... i follow the the 3rd step on discharging the battery 2, i used the 10 ohm 1/2w, it lights like a bulb, then 50 ohm same watt, again it smoked...
Whats good to know here Dennis is to shoot for a coil thats around 2-8mH in inductance. If you do this I think you will see some good results. This is done...
Hey Rick everything is fine with my setup. After 12 hours of trying to makeit work. I found out that By putting this big cap. I demagnetize most of my magnets....
Ken... interesting anomaly... can you elaborate on what you did? What size was the cap, how full was the voltage reading before you discharged it? Its...
Hey Gene, Ok, so with regards to winding the coil, once you've worked your way up from the bottom, say on the first layer, when you get to the top, do you wind...
We don't want to multiply posts on this list that go beyond the basic objective. That objective is to build a simple Bedini School Girl circuit as basically...
Hi Luther, I tend to wind it all the way to the top then pull the wire back to the bottom over a single turn and start again from the bottom up. Thus the wire...
Sorry, I made a mistake and gave the wrong directions. Apparently my email is still not being approved even though I am the owner! But when it comes I will...
*** CORRECTION TO *** HOW TO WIND A BEDINI COIL I'm doing too much at once and reversed myself for some reason. Below is the corrected instrcutions, in other...
Got it! Thanks for the instruction Rick. best regards, Luther rickfriedrich <rickfriedrich@...> wrote: *** CORRECTION TO *** HOW TO WIND A BEDINI COIL ...
You're sure eh? I noted a good deal of improvement with your prior noted way of winding the coil. I think my older coils are wound as you just described but...
Hmmm I'm lookin at the pic in the photos section... Its the same as you initially told us. You start at the bottom and wind clockwise if you are looking at...
Gene, Don't think too hard here. There was no confusion, I never changed from having the B in your left had to having the T in the left hand--never said the...
Yeap, looks like we're on the same page here. This is how I wound my latest full pittsfield and it works lovely. I'll try the up and back on my next pint...
Hi, There's something I don't understand. John Bedini has repeatedly said that the radiant energy appears in the battery itself. Why is everyone so concerned...
Dennis, You are thinking just right. It is ALL about seeing what kind of work the charged battery can do--and the less meters the better. Putting a meter...
Hi Dennis, Part of the "secret" is getting the right timed pulse of the right "consistency" for lack of a better term. You can pulse charge batts various...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
