No,
the PCM actually belongs or shall belong to my device to improve it...
I
was able several times to repeat my experiments with OU results. But as I said
it’s hard, to tune into the right spot and the excess energy is very few.
(was able to repeat single and dual battery ou experiments)
I
want to improve it now before I shout out that I have a smoking gun.
Regards,
Marcus
-----Original
Message----- From: YoTango
[mailto:yotango@...] Sent: Freitag, 21. Januar 2005 17:18 To: Bedini_SG@yahoogroups.com Subject: [Bedini_SG] Re: Notes on
PCM schematic
--- In Bedini_SG@yahoogroups.com, "Marcus
Wagner" <a.fallen.angel@g...> wrote: > I'll provide a full-circuit of my thoughts in
short time.
What happened to your Bedini device? Did you
forget about it?
Some feedback on the Pulse current magnifier circuit: The circuit stores the energy in the inductances and capacitors which then will release (electrolytic...
Dear Iceweller, Thank you for you comments on this. -Where can I find the formulas regarding this and how can I calculate the inductance of a coil only by...
Marcus, yes the voltage in this design is more or less constant (rippled based on output load), it is not intended as a voltage multiplier. If you intend to...
hello all , I've been reading thru all the posts and have been playing catch up for weeks , the link below is the best page i have found so far on coils and...
No, the PCM actually belongs or shall belong to my device to improve it... I was able several times to repeat my experiments with OU results. But as I said...
Dear Marcus, ... But ... energy ... gun. Your last report was 116% efficiency. That's the energy going back into the batteries. So there is no more energy...
Dear YoTango, I am still pending to do the new 555-timer, as you might already have read on the list, I am waiting for a new 555chip... so please be patient,...
... have ... Dear Marcus, I believe it's been 2 weeks so far since the 555 timer auto swapper started. If that's all that's holding you back then you can do...
Dear YoTango, Yes, that's all what's holding me back and that many eMails with questions of course... I'll either build a new 555 until the next weekend or do...
... Dear Marcus, If you have the smoking gun then hopefully people who are capable of making such electronic devices can start making them in their garage and...
Hello everyone, I now have finished the new 555-circuit and put it on my "old" circuit (schematic_ou.gif). Results pending, thumbs not up but not down, too. ...
Offline 
Send Email