Hello all: I decided to buy an ‘off the shelf’ alloy rimmed 16 inch cycle rear wheel, the spokes are the normal steel type but if necessary I can replace...
Hi Miki, I have a question for you. It has been asked before, in other ways, but I don't think we have the answer yet. Let's say I have a 7Ah 12v battery,...
Miki, does your conventional training have a good explanation for picture number 10 on this page? http://www.energyfromthevacuum.com/Disc2.htm The caption says...
Maybe the point is in the last part of: "I never found a clear answer on the battery swapping issue. I got: one should not use a radiant charged batt on the...
Hi all, this has just been tested on the Roto-verter technology, http://www.panacea-bocaf.org/RotoVerter.htm The RV uses resonance in RF frequency, this is...
Miki, that's what I'm doing, I'm testing different optins, cap pulsing, output diodes, single strand, multistrand, big batts, small batts, and others as well,...
I am building my first bedini motor(monopole) but i seem to remember that some motors are using a reed switch or hall effect device when i do not see this on...
Anthony, Here is a good starting point: http://peswiki.com/index.php/Directory:Bedini_SG:Schematic <http://peswiki.com/index.php/Directory:Bedini_SG:Schematic>...
Nick, ... must not have seen >some of the >latest circles. Check out google video and youtube, lots of vids about the subject. "Crop circles are treated as...
... motor, ... Instead of saying "disregarded", I really meant to say "regarded as a non-selfrunner" until a few successful replications have been made. Could...
Hey Nick, "Joe, I have a few questions about your solid-state set up. Do you have a schematic for your setup? Why did you decide to go with air core coils?" ...
Hi Anthony, the core's purpose is to increase the induction of the coil (as opposed to an air coil). Basically the core material has to be able to be...
Hi Anthony, I'm not sure if you intended this e-mail to come to me as the "To" section only shows your address and mine does not show anywhere in the message. ...
Thanks Mario regards Anthony From: Bedini_SG@yahoogroups.com [mailto:Bedini_SG@yahoogroups.com] On Behalf Of popo libero Sent: Tuesday, 8 May 2007 4:48 PM To:...
Hi all, Some of you have tried caduceus coils right? Out of curiosity, what experiences did you have with it, since it is supposed to have no impedance?...
Hi, I'd done some rudimentary experiments with this with a desulfator. It's supposed to have multiple resonances instead just one (like the normal inductor)...
Hey all, I think the missing link to success could be something we didn't pay enough attention to. I wasn't even in the group back then but going trough the...
I am currently building the bedini monopole as shown on http://peswiki.com/index.php/Directory:Bedini_SG#Plans but what other versions are there? Bedini's...
Anthony, I think v2 means two transistors, two power windings. You can add as many as you want ( there is a schematic in the files section)but before you...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
