Hi I was trying to do Layer 2 password recovery on 6509 switch, 1. I power cycled the switch and it rebooted. 2. When it asked for password, i pressed " Enter"...
Did you tried three enters, before 10 secs. ? Shibi Ali <shibi.alikunju@...> escribió: Hi I was trying to do Layer 2 password recovery on 6509 switch, ...
First you have to load an EMI IOS in your switch. (that is the Layer three image) then set the command "Ip routing" "ip cef" Then you have to configure your...
It depends on whether you are running CatOS: http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_password_recovery09186a00801349aa.shtml Or...
It depends on whether you are running CatOS: http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_password_recovery09186a00801349aa.shtml Or...
Thank you Adrian for your reply. Appreciated. I think i exceeded 10 sec before trying three enters. Will that make a difference? Thanks again, Shibi ... From:...
thats a good one.. but use Gateway load balancing instead of HSRP. because HSRP will use one of the 2 Internet links.. mehmood moon <mehmood_sajid@...>...
Traffic engeenering. noooo!!! all seems too easy until apears that word in MPLS and BGP. mehmood moon <mehmood_sajid@...> escribió: you can use both if...
Hi all, Recently I configured a 6500 with SUP-720 for transparent web caching with IP Spoofing. The configuration was quite simple. The idea behind IP Spoof...
Man , if you configure Two HSRP group in two router and make failover one-to-another so both links will be active and failover to each other just the diffrence...
We had the same issue before in our network as well. After a long struggle , we moved to another solution, bought a new L4 foundry switches and connected the ...
I have two Cisco Routers model C2851 with IOS c2800nm-ipvoicek9-mz.124-3g. These two routers are acting as peer routers between a Fiber WAN link. I would like...
have you ever. think about ipsec ? it is really easy.. chec on cisco.com how to do that.. basically you have to say.. this is my preshared key.. ...
Well , it is a simple task like others said , using IOS IPsec features as long as your IOS image has a ***K9** version. Your current ios version support it....
I think it will be both review the CCIE blueprint. ... De:: HappyLoomer Loomer <happyloomer@...> Asunto: [Cisco_CCIE_Lab] voice over frame relay is...
we are using Cisco 48 port 3560 POE switch,but when i trying to enter command Power inline auto it says invalid command..? did i have to conf more parameter in...
Exactly what do you want to do..? I mean why do you wath the power inline comand configured.? and giveme an extract of the comands you are introducing after...
Hi Ravindra, you cant configure power command in enable mode , you have to go in en --> conf --> interface mode of any port for configure the power inline cmd,...
I would like that if any cisco Phone atached to that cisco Switch it will get automaticaly power from Switch... Adrian Lopez <lomadrian@...> wrote: ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
