The pulse train needs to be 5 volt, 400 microsec wide pulses, at 60 Hz for 90 seconds. What is the rise time on a Kanalog relay driver. How about an Opto-Iso...
Try this:  #include "KMotionDef.h" #define BIT 46 main() {     double T0=Time_sec(); //starting time     double T1=T0;     do    { ...
Hay Tom, I have a Jog issue. Whenever i use the arrow keys on the keyboard to jog axis, i get a axis fault, and a lot of times the Stepper Drive faults out....
Hi Troy,  What are your Velocity, Acceleration, and Jerk settings in KFLOP. Try reducing the Acceleration. Also set the Jerk value to 10X or more than...
This was a big improvement, but still need to tweek a little more.Take a look at my motor settings in updated file and let me know if anything sticks out to...
Hi Troy,  Well I don't know much about your system but you have a Max Vel of 30000 and Max Accel of 200000. Which means you expect to accelerate up to full...
"Max Vel of 30000 and Max Accel of 200000..." Huhh...well, thats another thing i misunderstood. :) What would should the C program be , to match what i have...
Hi TK, Right now, I'm using KMotion and Mach3 to turn ON and OFF the Relay Drivers for: 152 FET Driver 0 None 153 FET Driver 1 ON/OFF by Mach3 (Spindle CCW/CW)...
Hi TK, Â That part I had done and able to control the Spindle using your "SpindleMach3DAC". Say for example that I would like to toggle the Flood on Mach3,...
Hi David, Â In Mach3 under Config|Ports&Pins|Output Signals|Output #3 set as Bit 159 (Pin 31 Port 2). Â Then in Spindle Setup UN-check "Disable Flood Mist...
That got it, as far as using keyboard for jogging. I uploaded screen shots of y axis with new settings. 6-4-2011(1) and 6-4-2011(2) As for jogging with my...
I can get my snap amp to reset and drive the brushed servos using a 24 volt supply, but when I hook up the main 75 volt supply it will not reset( the 2nd led...
Hi Todd,  What settings are you using? Do not attempt to clamp the voltage below the power supply voltage. If your supply is 75V then clamp at 80V.  ...
Hi TK, My DIY CNC having Encoder with Ref. Point at the mid of Encoder and I'm using this for Homing. How do I go about on your "HomeEncoderMach3" modification...
Hi David,  Well on initial power up the system will not know where it is at so it is not able to tell which direction to go to find the index pulse. After...
Hi TK, Â Thank for your help.....I performed Homing before turning off the machine, then turn on and performed Homing again and worked well to what I'm...
Tom, I turned off the power to a VFD that is mounted close to the kflop/kanalog/snapamp and now I can reset the snapamp with the 75 volt supply. It looks like...
I still think there is something else causing this, iam still getting a occasional error when using keyboard. I tried adjusting Velocity to 55000 in Kmotion,...
Hi my name is Marlon. I just recently received my KFLOP. I am fascinated by all this, and I would like to learn how to program my KFLOP. But I am a newbie at...
Hi Marlon,  For doing general things from Mach3 to KFLOP through the Plugin Mach3 has a NotifyPlugns(xxx) mechanism from Visual Basic.  Values of 10000...
