HI TK with Snap Amp its working fine, however with KMotion, some times i have to dbl click on the OUTPUTS before it works, I dont know why!. The other thing is...
Hi Azed, Regarding Encoder connected to KMotion: A single click should change the IO to an output (not a double click). It's not a good idea to connect two...
Hi Tom tyhank you very much for your reply. u r right this was the reason. I ve already checked the signal with OSC. and it drops down after connection.with...
Hi Azed, BTW all the console data gets logged to a disk file called log.txt within the KMotion\Data subdirectory. However if you want to write selected data to...
Thank you very much, that is really helpfull I ve another question, I ve a motor with a break, do I need to use a relay to switch the break on/off or i can...
You should be able to drive the Brake directly with the Kanalog Relay Switches (Mosfets) if it requires 24V and 1 amp or less. Make sure to add a reverse...
Hi Tom Remember Texonics? I am Mark S we talked several times last year (2008) I had an engineer leave and a couple big projects and I didn't have time to...
Hi Mark, Good to hear from you. Those sound like good plans. Users are always looking for a good source for servo motors. Yes the Mach3 plugin has the basics...
I am currently looking at using a DynoMotion Card to replace our current motion card. Our current motion card uses the ISA bus and LM628. We are pretty...
Hi All, I am using Kflop withe the latest Firmware. the problem the cars green leds flashes for so long time, and i have to switch on and off the power to get...
Hi Azd, How long do they Flash? With a USB connected and no application running they should flash for ~ 3 seconds. With no USB cable connected they should...
Hi All I am using Kflop+ kanalog with 4.12 frimware. However, the encoder channels on channel 1 is not working. i checked the Digital I/O its in the input...
Hi Azeddien, The way differential signals work is that you must put one input high and the other low to control the output. Putting the + signal at +5V and...
Thankyou Mr. TK very much for ur immediate response, however i have another question; what is the maximum number of axes i can have with Kflop+ kanalog...
Hi Azeddien, KFlop currently only contains 4 single ended quadtrature encoder counters. Kanalog converts these to 8 differential inputs. The 8 remaining...
Hi Tom, I am working on robot project where six axes of encoder feedback is needed. I will try with SanpAmp. however, if there is one board with six encoder...
Azeddien, Let us see if we can add more encoder channel to KFlop. It will probably take a week or two. TK ________________________________ From: Azd Md...
Is it best to use rotary encoders on the screw or linear glass scale encoders on the actual table? The CNC Brain uses both and I wanted to see how this...
I think this is a interesting question. You might be a bit more specific. Are you referring to steppers or servos? Obviously linear glass scales as the...
Hey TK, Had to chime in here. :) Are you saying that 1 Kflop is capable of handling both encoders and glass scales at the same time?Say.. for a 3 axis mill ;)...
Hi Troy, Yes it is looking like we can increase the number of encoder inputs from 4 to 8 which would be necessary also. TK ________________________________ ...
I was thinking of using servos with a rotary encoder connected to the driver and then using glass scales through the motion controller. I have been reading up...
Hi, I have algoerithms with morer complex data types such as structurs and classes. does the Kflop supports that, or is it possible to use Code composer studio...
