Greetings Robert,

It is not clear what you are trying to do. It might be best to call as
we could go back and forth over and over trying to figure it out. I
have many scripts that I have written for converting MIDI events. I
probably have what you need or can write it. I do not use CAL for a
variety of reasons. My scripts run in batch mode and are much more
powerful (when necessary) than CAL scripts. If Ron doesn't know how to
set up his own product, I doubt that I can help. I can provide or
write a script to modify the MIDI files to match your setup. 707 984
8356. Today would be a good day to call as I will be spending hours
sealing my deck and can talk on the phone while I do it.

Saturday, September 15, 2007, 11:36:07 AM, you wrote:
r> Hi all,
r> I'm having problems getting my Sustain Pedal to work. I'm using
r> Cakewalk and
r> have installed Ron's UMO midi board. I don't know how to set the
r> sustain
r> controller to activate my pedal. In the board setup program my pedal is
r> on
r> channel 2 and I set it to midi note 64. But don't know how to change
r> the
r> value of the sustain pedal to my pedal settings in the midi file songs.
r> Follow me? I asked Ron at Midiator and he's not sure on how its done.
r> He
r> mentioned the CAL program but I haven't had any luck with that either.
r> Do
r> you have any knowledge on this?

r> Musically, Robert Loeffler
r> www.robertsmusicalrestorations.com

r>

--
Best regards,
Spencer Chase mailto:spencer@...
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
http://www.spencerserolls.com
http://www.spencerserolls.com/MidiValve.htm
(707) 984-8356