Hi Neil-- The PID is sensitive to: 1) L and R slope differences 2) The flatness or steepness of the slope Take a look at entry #2 below which contains a PID of...
Hello, I've been using Focusmax version 36.0.77 without major issues. Recently, a Pinpoint pop-up screen appears when I open FM telling me that my 60 day trail...
Hi Jim-- Can you post the exact message - I do not believe FMx is sending this message - there is no reference to 60 day trial in the FMx code. Did you install...
Steve, This is very strange & only happens when I open FM. PinPoint 5.1.8 The 60 day trial period has expired. You can purchase a license for PinPoint 5.1.8...
Hi Jim-- FMx looks to see if PP is installed at startup. It found your DLL and then tested to determine if it was the full version of PP LT. You had the full...
Thanks Steve for your helpful comments. I'll see how it goes. If I get errors I'll let you know. Thanks again, John John ... From: SteveB Sent: 17 May 2012...
There should be no need to run Vcurves for each filter but you do need to measure the differences in focuser position relative to a reference filter (I use C)....
I use a TCF-S so the starting point is in the middle alittle high at 5600. It just started that the scope goes to 0, not a point a little off focus from 5600,...
Hi Marlin-- I use an Optec TCF also, and I do not see this issue. When the focuser is first powered up it will goto 0 then move back to the previous focuser...
Sure, Â it did go to 0 then to starting setting about 5600. Â At startup the focuser does its usual runt 0 then back to 5600. Â When I start the program it...
In the Files section V3.6.0.77 From: FMaxUG@yahoogroups.com [mailto:FMaxUG@yahoogroups.com] On Behalf Of Frank Sent: Sunday, May 20, 2012 3:25 PM To:...
Yes - there is a thread on this in past messages. From: FMaxUG@yahoogroups.com [mailto:FMaxUG@yahoogroups.com] On Behalf Of Frank Mraz Sent: Sunday, May 20,...
Hi Steve, After disconnecting my camera etc to work on my OTA, FMax fails. I assumed it had something to do with the fact that I may have plugged camera,...
Hi Dale-- I see the problem Find star binning = -15208x-15208 Goto the Setup Tab and hand select binning 1 - 4. This was reported by another user and has been...
Steve......  I am a new user to FocusMax. I have a C11 Hyperstar with a Microtouch autofocuser. In all honesty I have struggled using the system. I know...
Hello "Beginner"; You posted in your native language. Can you post in English? You may get more responses this way. Regards; Phillip in the San Diego, CA., USA...
Hi Dale; I to have a C11 with HyperStar on a CGE mount with MicroFocus. Even though the various Tabs in FocusMax have many settable parameter windows, these...
Hi Steve, The initial problem fixed. I then went to Aquire star setup to lower the star target range for V curves. After the V-curves, I clicked on setup again...
Dale, did you delete all entries in ASCOM Profile Manager relating to FMx before reinstalling?...joe :) "May You Go Among The Imperishable Stars" Joe Mize...
HIÂ Joe, It did not help. I had to uninstall Ascom totally and reinstall. All back to normal. Â Thanks Dale ________________________________ From: JoeMize...
Hi Steve, It was SP1. Just a note: After installing and loading my profile, there were the odd settings than I had to refresh, including type of plate solve,...
