HydroLightUsers : Message: question about the angle of full radiance output

HydroLightUsers · HydroLight Users Group

Want to share photos of your group with the world? Add a group photo to Flickr.

Having problems with message search? Fill out this form to ensure your group is one of the first to be migrated to the new message search system.

question about the angle of full radiance output

Message #24 of 91 |

If I use the full radiance output setting, the angle I get is below
the water or in the air or depends on the which depth I am gettting
from?

thanks

Tue May 8, 2007 4:26 pm

"cindyzju" <cindyzju@...>

Offline

Message #24 of 91 |

Expand Messages	Author	Sort by Date
If I use the full radiance output setting, the angle I get is below the water or in the air or depends on the which depth I am gettting from? thanks...	cindyzju	May 8, 2007 4:27 pm
The directions in H are defined by the partitioning of all directions into "quads", as shown in Fig 2 of the Users Guide, and as described in section 2.4 of...	Curtis Mobley hydrolightman	May 8, 2007 5:21 pm
So in the full radiance output file, if the radiance is just below the water surface (like say 0), the angle in that radiance table (theda and phi) should be...	cindyzju	May 8, 2007 9:14 pm
Correct. Thus a direction of theta = 45 deg, phi = 90 deg, is the same direction either above or below the surface. The theta,phi coordinate system does not...	Curtis Mobley hydrolightman	May 8, 2007 9:36 pm