Hi Pete. Great detective work! In my opinion, you would be better off using a modified cable or barrel adapter to deal with the problem, rather than altering...
I Have 2 lectro sr receivers..ch1 output is 5 to 10 db lower than ch 2. both are set at +5. Then this week the second unit has done the same thing. Even when...
Thanks for the info! Lifting the ground at either end of the audio cable did not work. I tried strapping pin 1 to the connector shells on the cables. The...
Hi Peter. More info from engineering regarding the grounding and fusing scheme in the UCR211 and UCR201... <<The problem with the 211's and 201's is not so...
ground loop issues can be major pains!! Senator Mike Michaels, c.a.s. Studio M Productions Senator@... Sound for Film, Video, Radio, TV and PA ...
Senator Mike Michaels
Senator@...
Jul 7, 2009 4:48 pm
1961
Have been checking around since your first post to see if this same symptom has come up elsewhere. We have had a couple of units here and 2 or 3 in the New...
Hello there professionals. The audio file below is from a recent shoot where I used a SR on a HVX200. I sent two channels to the SR from my mixer with two...
Hi Bryan, Sounds like loss of RF, maybe? I assume you checked the cables and that was not the issue. What band/channel were you using? What are all 4...
... Hi Bryan, I listen to the audio a couple of times and it sounds like a interference from two way radio as I had something similar while recording with the...
Hi Guys this is not related to lectrosonic so I understand if it is not publish. I am looking for the connector on the comms systems of the MRAP vehicles in...
Hi, What type of resistor should I use inside the ta5f connector of my COS-11's? Will regular 1/4 watt fit? Do they make smaller sizes that will fit/work...
Hello David Bogie David Bogie Eagle Eye Digital Video <http://www.eagleeyedv.com/> www.eagleeyedv.com 651-485-3153 Fax: 1-866-264-7121 [Non-text portions of...
David Bogie
dave@...
Jul 20, 2009 7:56 pm
1970
Hello Everyone, My name is Dave and I own a company that sells a unique application for timing sporting events and I am in need of some assistance and...
David Bogie
dave@...
Jul 20, 2009 7:58 pm
1971
Is anybody aware of any FCC restrictions on wideband transmissions, my local radio supplier said that wideband will be restricted in some fashion after 2013....
David Alley
alleydg@...
Jul 20, 2009 7:59 pm
1972
first of all, you do not understand the terminology "wideband" used to describe the "Venue Wideband"; that description means the front end antenna circuits...
Senator Mike Michaels
Senator@...
Jul 20, 2009 8:29 pm
1973
Old school approach would be to put an audio gate ahead of an audio controlled relay. The relay would provide a contact closure on the detection of audio input...
JR Tyler
jrtyler@...
Jul 20, 2009 8:48 pm
1974
check the products of RDL: www.radiodesignlabs.com Senator Mike Michaels, c.a.s. Studio M Productions Senator@... Sound for Film, Video, Radio,...
Senator Mike Michaels
Senator@...
Jul 20, 2009 9:44 pm
1975
Interesting project. RDL might have something to get you started. http://www.rdlnet.com/product.php?page=146 http://www.rdlnet.com/product.php?page=126 The...
Is it to be expected that the sound of a 401 receiver operating in 200 emulation mode would not sound as 'clean' as a 211 receiver hearing the same 200C...
As I responded to your same question in the Theatre Sound list last month, your local radio and cell phone supplier is referring to Part 90 Land Mobile Radio...
H. Cohen
henryc@...
Jul 21, 2009 1:01 pm
1978
Hi Pete. The DSP emulation is extremely close to the analog algorithm, but very slight differences in level and alignment of the analog receiver could cause...
The noise reduction mode is unavailable when the receiver is in 200 mode. (it would be great if it was!) Also, I could create a null without a phase reversal,...
" Further, the terms "wideband" and "narrowband" as defined by the FCC refers to operating channel bandwidth, not filter window " this is correct, however the...
Senator Mike Michaels
Senator@...
Jul 21, 2009 5:06 pm
1981
". . . the poster is discussing "wideband Venue" and "narrowband Venue", referring to Lectrosonics products defined by their filter Q (window), and at the same...
H. Cohen
henryc@...
Jul 21, 2009 5:21 pm
1982
maybe so, but I'd be willing to bet that if you heard 2 wireless systems set up as you describe, in a movie or TV program, you could not tell which was...
Senator Mike Michaels
Senator@...
Jul 21, 2009 5:40 pm
1983
Right you are. I had not looked at a 211 manual for the five years since its last edit. The analog filter was called a "tri mode dynamic" type, and it was on...
a bunch of used RX's will cost less than a bunch of new ones! but OTOH, you could go with new Venue's, unless you believe the differences you have heard will...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
