All, Did [do] I have problem today (have been out) and found this evening no VIS from MTSAT-1R after the 09:00 GMT slot this morning. I was hoping to animate...
Hi All. For a while now my receive set-up was just for METOP with all other channels disabled. I wanted to get back into receiving Meteosat again but have hit...
... Mike, The obvious things are: - check recv-channels.ini for a correct entry for: [EUMETSAT Data Channel 2] - check that PID 300 (hex 0x012C) is enabled....
... it and ... is. ... Thanks for your quick reply David. You got it straight away....I put in 0x012D for channel 2.....Doh! Bit of a red face here. ...
Mike Jupp wrote: [] ... I wish they were /all/ that easy to solve! Cheers, David -- SatSignal software - quality software written to your requirements Web:...
Hi All, I wouldn't normally bother you all with a bit of software, but this is a real gem if you use multiple screens. I have been using a KVM switch to move...
Ku-band EUMETCast is changing satellites before the end of 2008. See: http://www.eumetsat.int/Home/Main/What_We_Do/EUMETCast/SP_1217320833376 Cheers, David --...
That is a bit of a surprise. May not be good news for me as I had sighted my dish at the back of the house beside a fence looking to the left of a tree....
What does it mean? We have to move the dish? If yes how. I have it actually pointed to south. Thanks 73 de Enzo IK8OZV EasyLog 5 BetaTester EasyLog PDA...
Hi Vincenzo, All you will have to do is move the dish so that it points 4 degrees west in azimuth from where it is pointing now. No change to elevation. Don't...
Cheers Alan, hope this movement will not give me problem as I have a dual lnb on the dish to view the TV channels trough satellite. 73 de Enzo IK8OZV EasyLog 5...
That could cause you a real problem. Which other satellite are you aimed at other than Hotbird 13E? Alan ... E-mail message checked by Spyware Doctor...
No it should be the same bird 73 de Enzo IK8OZV EasyLog 5 BetaTester EasyLog PDA BetaTester WinBollet BetaTester D.C.I. CheckPoint Regione Campania Skype:...
... As it says on the Web site, the changeover period is 17-November to 17-December, you will have lots of time to readjust your antenna. I'm sure there will...
Yes setting up manually on 9E will be a little more difficult than 13E, as there are satellites at 7E and 10E and at the moment it appears that the transponder...
Because of the small difference 1 degree, will mean the a larger dish will be required? ... From: Ian Deans To: MSG-1@yahoogroups.com Sent: Friday, August 15,...
Seems like I have to pre-book a friend to help me on the roof... He wants to see Turin from there, so he must work!... :-) Uhm... it's time to remove old...
No your present dish will be fine Trevor. The problem with two satellites so close is in the tuning. A very small movement of the dish will move you between...
Thanks. ... From: Ian Deans To: MSG-1@yahoogroups.com Sent: Friday, August 15, 2008 4:41 PM Subject: Re: [MSG-1] Ku-band EUMETCast changes.... No your present...
I may have the same problem. At ground level by neighbours fence. Will probably get more of a problem with his overhanging trees. Cheers Alan ... E-mail...
In a message dated 15/08/2008 13:53:41 GMT Daylight Time, g3ujb@... writes: http://www.eumetsat.int/Home/Main/What_We_Do/EUMETCast/SP_1217320833376?...
geojohnt@... wrote: [] ... [] ... Is it really that bad, John? You could always put on an couple of extra Dish Alignment demos. I'm sure your services...
The system seems to be playing up at this end. I did not quote, nor intended to quote David. I said, in reply to John's note about "time for a cuppa" that...
... No problem, Tim. It was just how it looked. Indeed, I imagine quite a few of use will need "Grape Juice" for a while! Cheers, David -- SatSignal software...
All, Sorry for triple posting again but just to say I've now calmed down and had a look at satellite locations and see the 3 degree spacing is preserved apart ...
I'm not sure what the double negative means. Please expand. confused Alan :-\ ... E-mail message checked by Spyware Doctor (6.0.0.362) Database version:...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
