Hi, I made an extension of the lens hood (HB-23) for my Nikkor AF-S 17-35/2.8D for use with DX-formatted DSLRs (like Nikon D200) I cut an arch in black plastic...
Hi again, After recently having purchased the 17-35/2.8 and finding the HB-23 very lacking, using a DX-format, I began looking at alternatives. I stumbled on...
I have a speck of dirt, it's located somewhere inside the camera and shows up in the photographs. It is in the same spot in every picture, centered in the...
You have dirt on the ccd chip...it needs to be cleaned...their are many ckeaning kits out there...but if youve never done it before...send it to nikon. ... ...
It might be a bum pixel rather than a speck of dirt. In any case, if you can't get rid of it by yourself, a trip to the shop is in order. JC mikalle1...
I need help locating a drawing for the subject part. We are using F Mount Nikon lenses on two different unique cameras and I need the drawing so that I can...
Dear folks, I have a a 50mm f 2.0 Nikkor H lens which is optically and mechanically perfect but has one problem which annoys me: the filter holder (I mean the...
It's been a while since I opened one of these up, but as I recall the 50/2.0 Nikkor-H has a filter ring secured by a set screw. If that set screw is loose or...
Hi, thank you for your answer. I suspect I was not very clear in what I wrote. I know the screws are there (I can see them) and I know they are not tighten, my...
Can anyone tell me how to get the back of this camera to close. Something happened while it was in my car, and it will not close now. Something I am sure is...
Hi The N6006 is a very good, feature rich camera - BUT it has a weakness. The latch for the door is composed of two plastic pieces that interlock. The one on...
If you have the lens I'm thinking of, there should be only ONE set screw. It is located on the outside of the silver-colored filter ring. You may have to ...
I found a repair kit on ebay. Thank you. ... weakness. ... interlock. ... and breaks ... aluminum ... and it is ... placement. ... have seen ... the ... The...
Hi, Lou is right. Most of the e-bay sellers want $21 for one latch kit. However there is a seller that has five N4004 latches, without the screw and the...
Are you saying it won't CLOSE,or that it will close, but not LATCH? If it won't CLOSE, there's something in the way - an obstruction that needs to be moved or...
I have a Nikon F4 which doesn't load film: when I put in a roll, close the back cover and press the shutter release button, the shutter fires, but the spool...
I need to clean and re-lube this lens. The retaining ring on the front element is too tight to remove with a spanner, so I'm trying to disassemble it from the...
Anybody got one in good condition for sale? Bill ... Everyone is raving about the all-new Yahoo! Mail beta. [Non-text portions of this message have been...
It does not close. It seems spring. The door flaps open and it needs to be tied or a rubber band put around it. I can't figure out which part or piece on...
Hello to Everyone, I would like to invitate your folks, to visit http://www.mflenses.com and ask for help to make better Nikon section. Please drop me an email...
I think this topic was covered in several posts a little while back. Go to the group and see: http://tech.groups.yahoo.com/group/NikonRepair/ msgs.#6656 - 6661...
Gaffer's tape is like duct tape but much better (and more expensive). It is a strong, cloth-based tape that can be reused and leaves no sticky-plastic residue...
I have an old Nikon action finder (the one for the F which also fits the F2) where the ocular lens element is loose (you can hear it rattling). Probably the...
Marco
listman@...
Nov 26, 2006 1:38 am
6671
Hi everyone: The advance lever cap on my girlfriend's FM has mysteriously disappeared since her last shoot. The lever/ spring were in the bottom of the bag,...
Hi I need an AI conversion kit #B-53 for a Nikkor-H 300mm f4.5 serial # less than 480000. Pacific Rim doesn't have one, I have no idea where to look, google ...
Gruss Marco, To access the DA-1 elements, you have to remove the top chassis - lift off the leatherette on both sides, to reveal the securing screws. Once the...