I have begun making satisfactory B&W prints as I noted in my last post, which was answered helpfully. So now I am trying to create my own version of the...
hello, Brother in prints... I am travelling a lot, so to avoid my R1800 having clog heads I was using a small soft from MIS to print color bands on plain...
In the printing options, there is a pull-down menu for applying different dither algorithms (I assume these are applied during printing). The guide for...
I've seen some good reports on the forums about this paper, I ordered a pack to see how it performs on my 9600. Has anyone else tried it yet and what's your...
hi I'm new in this site I'm going to buy an Espon R1800 to use quadtone and 3 black channels print method I'd like to know how to get borderless print using...
Hi Marco, Sorry, but borderless is not supported. You'd have to print on larger paper and then trim it. Even the Epson driver warns about reduced quality for...
I have installed QtRIP and succesfully networked it to one of my Epson9800s having entered the IP address when prompted upon the curves install. I am now...
Hi, I started using QTR with Lightroom on my Epson R800, and I must say that the results in terms of "color" are very good! My only problem is that the...
I am an older darkroom experienced photographer and I have just downloaded the QTR software to my Emac running 10.4.10. I think I can get it all together, I...
Not sure if I am posting to the right group (I am a newbie). Please redirect me to a more appropriate support group if one exists :-) Looking to see whether...
Hi Robbie, No, you do not forfeit color printing. Just use your usual workflow with the Epson driver for color printing and use QTR when you want to do B&W...
Hi, I just printed an image that was supposed to be 765mm wide. It turned out to be 768mm at the top and 764mm at the bottom. Once in the frame this anomaly...
... is not a ... [mailto:QuadtoneRIP@yahoogroups.com] On ... to run ... dealing with ... I was looking for something more like checkboxes for each color for ...
Richard, When you say top and bottom, are you printing in portrait or landscape? What printer and did you remove pizza wheels? I had this problem with an Epson...
Hi Steve, I'm using a 2100 and printing landscape mostly. That long image I mentioned was on roll paper but I've had the same thing with A4 paper. I haven't...
The targets in the EyeOne folder are just a tad too wide for my Spectrophotometer to easily read white space at the spots marked Beg(inning) and End. So I...
Richard, Well, I don't have much experience with this other that what happened with my 3000. It sounds kind of like a feed problem, but then you'd expect it to...
I have encountered a problem with QTR when loading single sheets into a R2400. I previously used this printer and QTR with my laptop utilizing Vista. When I...
For information, I've been printing very successfully (from where I stand) on Harmon Gloss FB A1 using the following settings with an Epson 2100. Paper type =...
I've had no problem with image size on A5 and A4 printing, but hit the first QTR problem with A3 today. Images were sized in Photoshop as 38cm on the longest...
Paulo - weirdly enough I'm using the photo-black ink. I had to reduce ink density to -50 to get them looking right. All a bit rushed at the moment (and STILL...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
