Image not showing up any longer. I'm looking to burn pellets as well and would
love a diagram or photo of your solution.

dave

--- In SedoreUSA@yahoogroups.com, Mark Jannini <unadillawood@...> wrote:
>
>
>
>
>
> ________________________________
> From: David Lantz <david.m.lantz@...>
> To: SedoreUSA@yahoogroups.com
> Sent: Thursday, December 22, 2011 12:17 PM
> Subject: Re: [SedoreUSA] Re: Problem when using pellets
>
>
>  
> I'm interested in this, is it possible to get a picture of the setup?  I'm
just not getting the description.
>
> Thanks, Dave
>
>
> On Thu, Dec 22, 2011 at 10:13 AM, Mark Jannini <unadillawood@...> wrote:
>
>
> > 
> >Take a pipe about 4 inches around and cut a u notch in the bottom .
> >
> >
> >Clean out ashes/cinders
> >
> >
> >You can use light stove pipe for this
> >
> >
> >No more than 1/3 the pipe 3 inceh high this will be the bottom front of the
pipe, place this pipe against the heat shield side of stove,notch
facing burning side ,pipe to be cut inch lower than lid fill with pellets and
burn.
> >
> >
> >No pellets in the pipe only fill around and to the top 
> >
> >
> >This will solve your problem as it will balance the combustion air
> >
> >
> >
> >________________________________
> > From: Dana <gottsegnet@...>
> >To: SedoreUSA@yahoogroups.com
> >Sent: Thursday, December 22, 2011 9:26 AM
> >Subject: [SedoreUSA] Re: Problem when using pellets
> >
> >
> > 
> >My husband is very good at cleaning out the ashes. The only thing that works
for us is to not use pellets, or to only add in a little on top of wood. But we
have three tons of pellets and not nearly that much wood so we really need to
figure out a way to burn this.
> >
> >--- In SedoreUSA@yahoogroups.com, "Doug Marshall" <dougm@> wrote:
> >>
> >> Dana, we use hardwood pieces from a door manufacture and I have observed
> >> that our Sedore purrs like a kitten if we cleaned out ashes after we notice
> >> the stove burping. doug
> >>
> >>
> >>
> >> From: SedoreUSA@yahoogroups.com [mailto:SedoreUSA@yahoogroups.com] On
Behalf
> >> Of Dana
> >> Sent: 12/19/2011 8:12 AM
> >> To: SedoreUSA@yahoogroups.com
> >> Subject: [SedoreUSA] Problem when using pellets
> >>
> >>
> >>
> >>
> >>
> >> We replaced our chimney and the stove runs much better. It doesn't give off
> >> nearly as much heat as it did last year, but the smoke is going outside
> >> rather than inside so I guess it is a fair trade.
> >>
> >> We have a bunch of pellets, though, and when we use them the stove has a
> >> tendency to puff.
> >>
> >> It will run fine for awhile and then the lid will lift up, sparks will
spray
> >> out along with a puff of smoke.
> >>
> >> What can we do to prevent this?
> >>
> >> Dana
> >> http://roscommonacres.com
> >>
> >
> >
> >
> >
>