Can anyone help me with the basic setup of an SG560 - firmware version 3.1.5u4. The SG560 sits between my ADSL modem (connected to PortB on the SG560) and a...
... It depends on your DSL setup, you can either just forward the ports in the NAT page or you can set up definitions for multiple ports and call it something...
I am using the SG530 Version 2.1.4. I have a SG560 version 3.1.5u4 that I'd like to upgrade to. I am using content filtering and would like to add my white...
Here is the scenario I am dealing with. At our main location we have an office section with one of our owned affiliates leasing it. They have their own...
Hi - I think the problem should be easily solved. 1st I assume the SG300 at Site A has had its firewall disabled. If not then follow this procedure. ...
My 5th step was not very clear: Make sure that you add a static route on the Linksys router at Site A with the following details: Target : LAN Ip address range...
Hi, Im not sure if i m following it right, but you can check as i could find this stuff on simulator. In the Systems Tab ( on the left hand side) ---> Advanced...
thanks for your input drumni3assboy that little bit of assistance really made a difference! i stuck with it and got it going! yesterday i got onto the snapgear...
Hi, We are using a SG575 on the central site and about 70 IPsec tunnels with sg300 on remote sites, all of the remotes use dynamic IP, the problem is whenever...
... It worked. Thanks for your help. I doesn't say much for SecureComputing Support staff. I was on the phone with them 2 times trying to fix this. Guess I...
Sameer, Thank you very much for the reply. I finally got a chance to play with it. The URLs can be added by using a space and comma from both locations (Web...
Because the remote ends have dynamic IP's you cant enable the Dead Peer Detection or keepalives as you say. If the remote 300's registered with a dynamic dns...
Need help for SG580. I connected my laptop and my server to the SG580. I try to block my laptop from talking to the server using the packets filters, but to no...
Are your server and laptop on the same subnet and port of the SnapGear? If so, the SG580 would be unable to filter those packets since they do not traverse...
I've set up over 2 dozen SG300/550/560/580 routers in the last year alone, and it figures that MINE is giving me grief. I've got a brand new Comcast cable...
I just reset the entire unit and then I could configure it properly. This stinks because now I have to manually input all my IPSec tunnels again as I tried to...
Can anybody tell me if any vendor specific attributes need to be added to the IAS Radius server setup in Server 2003? when operating an SG560 as a VPN endpoint...
If it's of any help, we have a similar configuration - an SG580 acting as a PPTP server using IAS on Windows 2000 for radius authentication. I don't remember...
My SG560 won't allow access from outside my internal network until I access the Internet from inside. After I do, it works fine all day. But, after it's been...
If you save both of your configs (after respectively restoring) in text-format Backup/Restore -> Text Save/Restore you might well be able to run 'diff' to see...
... Not used/needed right now. Next Major release will support user-groups on devices. Vendor attribute(s) will be able to be used to link/associate on-device ...
... If you give me/us the relevant ticket number I can take a look at what the story is here. presumably by 'access' from the internet you mean port-80, or...
Since there's official representation on this list, would this be the proper channel for submitting feature requests for future version of firmware? ... Ryan...
Okay, I'll just post this here and we'll see if it flies or not. Would it be possible to limit upload/download capabilities of vlans? For instance with an...
I hve an SG560 acting as a firewall on a small SBS 2003 Std R2 installation. The SBS firewall is not set up. Remote VPN connections to the SBS server have been...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
