Hello,. everyone. I was wondering if anyone had tryed to use a usb/serial adapter with the sumo11 and IC 5.0. I just bought a new comp, and it has no serial...
RidgeSoft sells a USB to Serial adapter which should work for you. See http://www.ridgesoft.com/shop.htm, about 2/3 of the way down the page. Regards, ...
Awsome, thnaks for the replay. I'll most likly try to pick one up today at office depot. _Duane An off topic note: AMD64 x2's rock.... I cant belive how lag...
The current IC is 6.014 and can be downloaded from here: http://www.botball.org/educational-resources/ic.php. It comes with the sumo11 support libraries. Jim ...
... I don't have any direct experience with this particular piece, but as stated before, any correctly installed USB to Serial Adapter should do. The page you...
Duane, I'm fairly sure, as Jim said, that this adapter, as well as others will work. If you already have an extra USB cable the Parallax version is a...
Terry Grant
tgrant@...
Oct 23, 2006 4:28 am
503
I have a implementation of a controller on the Sumo11 that control the speed of the car. But it takes about 5 seconds or so to bring the car to the desired...
Using processes is one way to solve this kind of problem. essentially, you have a system where you want to perform or continue to perform some action while...
Will a process run independent of the main once it is called from the main? What I want to do is to check for a condition 'continuously' and basically,...
Be sure you read the help for start_process() and kill_process(), defer() and hog_processor(), as well as the tutorial pages in the help for process...
Thanks! This helps a lot. Jim Peterson <jimcp@...> wrote: Be sure you read the help for start_process() and kill_process(), defer() and hog_processor(), as...
Dear All, Greetings !!! We are a Mixed Signal IP and ASIC Relization Company offering a portfolio of digital and analog IP and full range of design services....
We need more information, how did you attach your LCD? Did you use it with the Sumo11 expansion board? Was it an LCD supplied with a Sumo11 kit? Please be more...
Is there a ground-loop problem if I power the sumo with one source and the servos with another, especially if the sources are different? Also, what are the...
Hi, i currently am using a sumo11 which i got for free for a project. It came with RoboJDe software which i would like to try out. But it won't recognize my...
There are two seperate power inputs on the Sumo11, one is specifically for powering the logic and processor and is regulated through a 7805 voltage regulator....
There are two seperate power inputs on the Sumo11, one is specifically for powering the logic and processor and is regulated through a 7805 voltage regulator....
Thanks, i figured it out. I am still waiting approval to be added to the Robojde group. My problem was you can't change the baud rate on version 1.2.0. The...
I have the need to drive 3 large 12v motors. I have already made 3 H-Bridge controllers using the NC LMD18200T IC's. I cannot figure out by the schematic, if...
On the Sumo11, I sacrificed the second two PWM ports to create the servo ports. There is a detailed chart of how the ports are broken up in the Expansion board...
I was wondering if someone could advise me on troubleshooting stage two of the assembly of the main board (ie. adding the CPU and serial connections and all),...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
