Will a process run independent of the main once it is called from the main? What I want to do is to check for a condition 'continuously' and basically,...
Be sure you read the help for start_process() and kill_process(), defer() and hog_processor(), as well as the tutorial pages in the help for process...
Thanks! This helps a lot. Jim Peterson <jimcp@...> wrote: Be sure you read the help for start_process() and kill_process(), defer() and hog_processor(), as...
Dear All, Greetings !!! We are a Mixed Signal IP and ASIC Relization Company offering a portfolio of digital and analog IP and full range of design services....
We need more information, how did you attach your LCD? Did you use it with the Sumo11 expansion board? Was it an LCD supplied with a Sumo11 kit? Please be more...
Is there a ground-loop problem if I power the sumo with one source and the servos with another, especially if the sources are different? Also, what are the...
Hi, i currently am using a sumo11 which i got for free for a project. It came with RoboJDe software which i would like to try out. But it won't recognize my...
There are two seperate power inputs on the Sumo11, one is specifically for powering the logic and processor and is regulated through a 7805 voltage regulator....
There are two seperate power inputs on the Sumo11, one is specifically for powering the logic and processor and is regulated through a 7805 voltage regulator....
Thanks, i figured it out. I am still waiting approval to be added to the Robojde group. My problem was you can't change the baud rate on version 1.2.0. The...
I have the need to drive 3 large 12v motors. I have already made 3 H-Bridge controllers using the NC LMD18200T IC's. I cannot figure out by the schematic, if...
On the Sumo11, I sacrificed the second two PWM ports to create the servo ports. There is a detailed chart of how the ports are broken up in the Expansion board...
I was wondering if someone could advise me on troubleshooting stage two of the assembly of the main board (ie. adding the CPU and serial connections and all),...
I am using a standard serial port, and I checked that the cable and the port are able to connect to other brands of microcontrollers that I have. ... stage ......
I have a question about the connections on the LCD that came with the expansion board. There are 14 pins, and the LCD in the kit I got has 16 holes. Which 14...
Use pins 1 through 14, pin 1 should be labeled, but if not, pin 1 will be to the far left of the board closest to the side edge. Pins 15 & 16 are for the...
It sounds like you might have some part installed incorrectly or in the wrong spot. Check your diodes, they are polarized and have to be installed with the...
HI! I own a Sumo11 Board with IC 5.01 on the Sumo11 Board ... So I wanted to start Interactive C to programm a little bit but then when I need to choose...
Ronald, I know that the latest IC still loads version 4.30 to other targets such as Sumo 11. I'd look for other reasons for the crash. If your battery is weak...
Ronald, One more thing, to use IC v.4.30 on your Sumo11, all you have to do is reload the firmware. V.5.01 did have fixes for the HB & Sumo11, but KISS didn't...
RidgeSoft is pleased to announce the availability of the RoboJDE Java-enabled robotics software development environment version 2.0. The major highlights of...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
