Pin 1 = +5V Pin 2 = Ground Pin 4 = Video Mike ... ____________________________________________________________________________________ Be a better friend,...
FYI AFAIR The video-out signal of the keyboard/CPU does not comply to the composite standard. The voltage is a little bit too high so you have to put an...
Opps, That's news to me. In the past (30 years ago) I've done the RF modulator thing and tapped the 5volt line for power. An driven a generic composite monitor...
Never heard that one. I've connected pin 4 to the center and pin 2 to the outside and have driven several different CVBS monitors for the last 15 years. ...
News to me too. My model1 video cable recently fell apart and I made a new one. I didn't use any resistors and it works just fine on an old generic b/w...
Hi Jan, I looked it up: The composite video is 1 V (p-p)(ref Wikipedia) . The output of the TRS-80 is 1.8V (p-p) (ref: TRS-80 technical reference handbook). So...
OK Butch, you're probably right. But I think that we can safely assume, as you did, that most, if not all, CVBS monitors can handle this. Also because in the...
I have a Model 16K Level II model one that has not been used in 20 plus years. The LED lights up, but there is no picture on the monitor. I tried a composite...
Normally if you have a CPU or PROM issue, you'll get junk on the screen. No junk means you are getting no signal. It could be there is no clock and therefore...
... screen. No junk means you are getting no signal. It could be there is no clock and therefore no video. Hit enter a few times and then enter cload. If the...
... Not a common problem, I think it is more common to get garbage on the screen. No video... you might turn brightness and contrast on the monitor all the way...
I actually have a Model I with the same issue. Maybe this is a good time to open it up and see what's wrong. I got it for free from someone and it was...
Thanks, I'll need to investigate further. At one point in time the machine had the power supply plugged into the video jack (by accident) but that was repaired...
Check the photo album for a few pictures of my L1/L2 card. I designed this card mainly as an exercise for learning the pcb123 software. Not much to it, just a...
Any Luck David? I'm going to dig in this weekend. ... good time to open it up and see what's wrong. I got it for free from someone and it was covered with mud...
So finally my new application, a spinnoff from wav2cas, is ready for release. Those last quirks were more difficult to solve than I had imagined... Play CAS is...
... plays ... also ... Too bad my real Model III doesn't work, else I would defenitely have given it a try. This seems to be a great utility. Keep up the good...
... Dave, Both Attila Grosz's and Matthew Reed's emulator will output casette files as WAVs. Not sure about bitrates with MP3s though. Terry ... From: David...
Hi From: David Sutherland [turnkit@...] ... Play CAS can save a WAV also. You find 'Save Wav' file in the options menu. The format is 22050 Hz mono 8 bit...
The May 2008 issue of Computer Power User magazine has a Model III on its cover for its Mad Reader Mod section. Abit AN-M2 with a AMD64 X2. An old 12" lcd...
Hallo, http://content.techrepublic.com.com/2346-13636_11-193055.html?tag=nl.e099.dl 032608&tag=nl.e099 They "cracked" an osborne 1 this time. I noticed that a...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
