Although the Tandy 1000EX is quite limited to what it can be run on it, it's still a PC(jr) nonetheless. It also consumes abour 28 watts max. Check out the...
The flat screen monitor use substantially less power than do the CRT types. If you use a VGA card (which is not possible on all the 1000 models), and you don't...
... You need to boot DOS off of a floppy disk, then run the setup program, which is here: http://support.radioshack.com/Download/setup/3800.EXE If you need a...
Hello, i have a 1500hd when i turn on i get hard disk read failure message. tried to reload dos diskette, but didn't change anything. just keeps repeating...
I have several Tandy 1500HD laptops, and one 3800HD (looks exactly same, but more C: and RAM, I guess). None work 100%. Some boot fine but A: is no good, and...
Just thought I'd let you all know about this event the weekend after next. You have until tomorrow to postmark your payment for advanced (reduce) admission...
I hope this isn't out off line or illegal, but I'm looking to label 3 system floppies for the Tandy 1000EX. I acquired the images from TVDogs site and recently...
I like to have a back-up unit for each of my Tandy 1000s. I've never had any major failures, I just don't want the possibility of one causing a problem. For my...
I'm announcing Bitchin100 Magazine, the print & PDF magazine targetting classic 8-bit bus laptops, of particular relevance here, the 1100FD, 1110HD, 1500HD,...
The original TL had a '286 (I think). So is the TL/2 more or less the same thing, w/a new case? In any event, do the original keyboards work w/a TL/2?...
Jan Vanden Bossche <jan80@...> wrote:the TL/2 had a smartdrive interface on-board, i.e. an XT-IDE. It could be equipped with either a 20 or a 40 MB HD. ...
Hallo ... From: "Chris M" <chrism3667@...> ... Not a true AT IDE, but an XT one. Not only Tandy used it, but e.g. Atari and Commodore too, and other...
Chris M- The 8-bit Tandy 1000s with a "Smart Drive" interface use only XT-IDE drives. These were relatively rare, and were only 20 or 40 MB. Tandy did make an...
... conner cp2024 that won't boot. Thank you Gary ... No. The CP2024 was a 2-1/2" XT IDE drive that drew power through the data cable. It was probably...
Just "inherited" a Tandy 1000TX from a yard sale--now looking for software to get it up and running. I know I need 720K 3.5" diskettes, but what should I use...
... See the Tandy 1000-series FAQ in the files section, question II.K.5. ... The TX came with DOS 3.2; I haven't been able to find original system disks for...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
