The EEstor battery has already been proven to be able to be charged in 5 mins and exhibits the same sort of charge density that a tank of petrol does. It is...
THOSE 2 AUSTRAILIAN INVENTORS ARE NOT INVENTORS BUT THEIVES. Referring to the link at the bottom of this page. They have not invented anything but are seeking...
There is a file folder in the files section labeled Adams Doc Files and then it says G-Members below it. Apparently G-Members are the only ones allowed to...
Did you apply feed back to recover anomolous energy that turns up during switching and feed that back to the source or a cap across the source? Russel P....
The Motor I am currently building will start with embedded copper strips in a peice of plastic like Roberts star wheels but will probably end up with a digital...
Hall switches can work very well if you get them setup right. Some peole have a lot of sucess with them, I havent had much luck with them though. I am no...
Hey guys, Look what I found. http://pesn.com/2009/10/06/9501580_TWM_Technologies_free_energy/ Looks like another Adams motor replication; Just like Lutec did. ...
That is very close and a long way ahead of the lutec machine. Not how both sides of the magnets are used but the cores are not in line so you are not using...
Yes I did all that and a few more craizy ideas. I also tried the hall effect, reed relays, Bedini ssg switching styles and the original from Robert accordingly...
Hi Fiditti, We have often done multiple windings on a single coil core. You just wind them all on th former together but it is better to get you strands and...
Russel, Thanks for your information on core winding. I appreciate it very much. It sounds like these guys have three stationary disks with 5 electro-magnets...
Yes you have read that correctly I think. No Robert made a single rotor machine with 4 neo magnets on the rotor and 2 coils single wound but the arrangement...
Robert Adams and Harold Aspen had a patent for a multi rotor Motor Generator very similar to what we have just been looking at. Harold filed the patent in the...
Russel, Thank you very much for all the great information. You have opened some great doors for me. Regards, Fiditti Russel, Thank you very much for all the...
Bedini is using a keyed part that allows him to connect his magnet holding disk/wheel/rotors to the drive shaft. The part is connected to the disk via three...
I am not quite sure what part you are talking about but have always just used a litle epoxy glue to hold the rotor to the shaft. Rick is selling parts and...
Russel, Thanks so much for your help. The part I am seeking is a part that screws to the side of the rotor with three screws and fits over the drive shaft. ...
Dear guys;                 I have a question. Does this machine can be use for powering an electric vehicles.  regards  Alongaga Jonos ...
