I looked into it more furthure, reinstalled drivers, worked, got nearly 1.5gb back on it, reinstalled drivers again, I am transferring more right now, no...
... If you are using Rockbox, look at the battery voltage after it is plugged in for a while. If it is well over 5 volts, then it is probably charging. In the...
hi list, I told some weeks ago that the playlist generator in rockbox adds resource files if there are any when copied mp3s on mac. got this solved by learning...
I ended up fixing that by reinstalling the drivers, each large transfer I have to do that. Someone earlier in this post said that he uses a 9v 500mah yet in...
got my hands on an archos6000 but i find that regular headphones seem not to fit entirely in the jackport..? i didnt want to press it all the way in for fear...
I've never had that problem with mine. I suspect your Jack is damaged, assuming that your headphone plug isn't damaged instead. Inspect it carefully. I once...
Mine is quite tight when inserting any. You have to really press it to get it to snap in, otherwise you only get the right or left channel (don't remember...
The size is quite standard. It may be that the 6000 has a little more resistance in it's jack than most, one of the contacts is bent inward, or there is...
... wrote: If you want to have huge amounts of files in a single directory, go to: Menu-General Settings->System->Limits->Max files in dir browser and set it...
I want to thank everyone who has contributed to this site. I finally took the plunge and installed a 40G hard drive in my AJB 6000. Through this site I was...
... u re an unorganized punk :-))) sort your stuff in folders and use playlists if u want to tie them together I have 8000+ tunes on my 40 gig v1 recorder and...
Get a second (or even third) set of battaries. They aren't too expensive. Dan ... ===== Dan Mastous dan@... www.mastous.net Tomorrow; Which of you has...
... Do you have the JB configured to turn off ("car adapter mode" plus a time out set) when you turn the car off, or are you letting the JB play until it's ...
wow.. thanks guys for the eyeopener about the jackport.. i never even considered a damaged port because the unit itself was immaculate and didnt have a scratch...
... what I sometimes have from customers (I repair tv and audio stuff) is that the tip of a broken plug remains in the socket, u may try with a needle from the...
What is your amperage on your car power supply? I was concerned about reports that high ma adapters were a problem. I've been using an adapter rated at 400...
Sounds like you got things backwards. The ma rating of the adaptor has to be more than the ma draw of the device in use. If the ma rating is too low, you...
... Yes this can happen, but I don't think it is likely. A 400ma adapter will probably have a 1 Amp rectifier diode which would be able to take the short...
Here is my review of my new earphones I have recently received. Model # MDR-EX71SL 16ohms 100mw power handling 100dB sensativity 6 - 23,000 Hz freq response ...
I have a followup, unfortunately I never tried these on anything other than my jb6000 in the review, I put these things on my stereo, they definently rock, I...
The 'Mod' will definitely improve the situation. The XL71's are notoriously bass heavy, and mid light, and are best if all settings are flat, so turn Bass and...
Are you sure you had obtained a good seal when putting these in? The EX series earphones are shipped with 3 different sizes of tips so that you can obtain an...
This is not the ex, this only comes with two sizes of earbud, I am getting a good seal. As you have seen in my reply these I definently misjudged them with my...
Yes, sorry I didn't get to your second message until after I had sent the first. I had the JBR20, which did a lot better amplifier wise, so I am not real up...
I will probably do that, i am short on that, dont feel like goin up to the the store so ill slap liquid electrical tape on the capacitors on the capacitor...
Re: Hot I've never found it to be a problem. When I did the first one I had a minor problem getting the wired caps to stay put while I re-assembled the circuit...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
