--- In blassic@yahoogroups.com, "djpeterso23662" <peterson@...> wrote:
>
> Hello! I am new to the group and brand new to Blassic. I have been
> looking at several BASIC implementations for some old-school
> programming, and am very pleased with what I have seen of Blassic.
> Great job!
>
> I have obtained the 0.10.0 and 0.11.0 archives with source code and
> have built Blassic on Linux and on Cygwin. The error I receive with
> the Cygwin build (either version) is
>
> > ./blassic
>
> Blassic 0.11.0
> (C) 2001-2005 Julian Albo
>
> Ok
> Error reading file
> >
>
> I can run a .BAS file from the command line successfully if it is a
> couple lines long; longer programs bomb out immediately. Eliza.bas,
> for example, says ? Error reading file in 200.
>
> Any suggestions on this problem. I did not receive any noticeable
> errors from configure or make, so I am a little stumped.
>
> I am hoping to use Blassic as a simple method of implementing CGI
> scripts under Cygwin/Apache. I think that I can get some interesting
> results with this combination.
>
> Thanks for any suggestions!
>
> David Peterson
> Poquoson, Virginia USA
>
Well, I would recommend to use version 0.10.0 of Blassic because the
version 0.11.0 isn't stable yet. I even didn't manage to compile
version 0.11.0. Version 0.10.0 runs pretty well, some further
discussion and projects are on: forum.basicprogramming.org.
(Too much spam on this yahoo forum ...)

Best wishes,

Cybermonkey