Forgot to connect GND ? ;)

Regards,
Mihai


--- In booksbybibin@yahoogroups.com, "im_shield" <im_shield@...> wrote:
>
> Hi there! I've made a programmer but is not working(don't know if is the uC or
the programmer fault) . Sice i can't test if the uC is fried, i want to test if
the programmer do its job. For that I attached some leds coresponding to the
MOSI, MISO, SCK, RESET and VCC. I use Pony Prog for reading the device.
> The serial Probe test inside PonyProg said "Test ok". When i try to read or
Write, the MOSI and SCK led start to flash (alternate, with MOSI more brighter).
VCC led is on. The other 2 leds (RST and MISO) are not doing anything. Can
somenone please tell me how those leds should behave so the programmer work
well? Or do u know any onther method to test it? Thank you!
>