Ok it's done..It reads the microcontroller, serial probe is ok, but when i write
it finishes 100% and the message "Write failed" appears.
I saw FAQ on lancos.com and they sayd there to modify some values inside
ponyprog.ini (file found where ponyprog is installed).I modified the values but
still the same problem.I use a USB to serial converter since i don;t have serial
ports. Fuse bits can be responsable for something like that? Thank you for your
answers!

--- In booksbybibin@yahoogroups.com, nitin chaudhary <nitin2162000@...> wrote:
>
> When you reset the system through command in ponyprog, the reset led should
blink only once. For wrong connection reset led will blink more than one
>
> --- On Sun, 28/6/09, im_shield <im_shield@...> wrote:
>
> From: im_shield <im_shield@...>
> Subject: [booksbybibin,www.booksbybibin.tk] How does an ATMEGA16 programmer
works?
> To: booksbybibin@yahoogroups.com
> Date: Sunday, 28 June, 2009, 7:06 PM
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> Hi there! I've made a programmer but is not working(don' t know if is
the uC or the programmer fault) . Sice i can't test if the uC is fried, i want
to test if the programmer do its job. For that I attached some leds coresponding
to the MOSI, MISO, SCK, RESET and VCC. I use Pony Prog for reading the device.
>
> The serial Probe test inside PonyProg said "Test ok". When i try to read or
Write, the MOSI and SCK led start to flash (alternate, with MOSI more brighter).
VCC led is on. The other 2 leds (RST and MISO) are not doing anything. Can
somenone please tell me how those leds should behave so the programmer work
well? Or do u know any onther method to test it? Thank you!
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> ICC World Twenty20 England &#39;09 exclusively on YAHOO! CRICKET
http://cricket.yahoo.com
>