Done...I won't use USB to Serial converter ever..It's working great with serial
only :D..One more question: i did not attached to my programmer a crystal
oscillator, but i have it on the board i want to use the microcontroller ( is a
7.3728 crystal). So my question is: can i program my uC with the fuses set so
that my uC work with an external 7.3728 crystal, even if i use a programmer that
don't use such a crystal? To be more clear, after i program my atmega16 on a
programmer without external crystal (but with fuses set for external 7.3728), i
want to take it out the socket and place it on a board that uses external
7.3728..Is it ok? Or should I have to attach an external 7.3728 to the
programmer also?



--- In booksbybibin@yahoogroups.com, "im_shield" <im_shield@...> wrote:
>
> Ok it's done..It reads the microcontroller, serial probe is ok, but when i
write it finishes 100% and the message "Write failed" appears.
> I saw FAQ on lancos.com and they sayd there to modify some values inside
ponyprog.ini (file found where ponyprog is installed).I modified the values but
still the same problem.I use a USB to serial converter since i don;t have serial
ports. Fuse bits can be responsable for something like that? Thank you for your
answers!
>
> --- In booksbybibin@yahoogroups.com, nitin chaudhary <nitin2162000@> wrote:
> >
> > When you reset the system through command in ponyprog, the reset led should
blink only once. For wrong connection reset led will blink more than one
> >
> > --- On Sun, 28/6/09, im_shield <im_shield@> wrote:
> >
> > From: im_shield <im_shield@>
> > Subject: [booksbybibin,www.booksbybibin.tk] How does an ATMEGA16 programmer
works?
> > To: booksbybibin@yahoogroups.com
> > Date: Sunday, 28 June, 2009, 7:06 PM
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> > Hi there! I've made a programmer but is not working(don' t know if is
the uC or the programmer fault) . Sice i can't test if the uC is fried, i want
to test if the programmer do its job. For that I attached some leds coresponding
to the MOSI, MISO, SCK, RESET and VCC. I use Pony Prog for reading the device.
> >
> > The serial Probe test inside PonyProg said "Test ok". When i try to read or
Write, the MOSI and SCK led start to flash (alternate, with MOSI more brighter).
VCC led is on. The other 2 leds (RST and MISO) are not doing anything. Can
somenone please tell me how those leds should behave so the programmer work
well? Or do u know any onther method to test it? Thank you!
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> > ICC World Twenty20 England &#39;09 exclusively on YAHOO! CRICKET
http://cricket.yahoo.com
> >
>