hi all i have jetway artis 738-s1 sound card with the cmi 8738 chip iv tried a few drivers even the xp drivers on the cmi site and still ne joy, has anyone had...
you have to enable the virtual 5.1 sound in the Mixer.exe program with the WDM drivers ... From: kevstir2000 To: cmi833X@yahoogroups.com Sent: Friday, December...
Hi I'm still trying yo down load every time i get to 1 or 2 meg it says down load complete but the file is 3+meg fails also from driver.com to look at ...
I have an M-Audio Dio 2448, which has no analog inputs, only digital optical and coaxial. You switch between them simply by only sending a signal to one or...
Hi I put go!zilla on my machine and it down loaded the file from drivers.com OK I used av310 to find the driver {drivers all} to open hope this helps al ...
Hi I am new to this group :) I have an ASUS A7V266 Motherboard which comes with a CMI8738 soundchip. I also downloaded and installed the newest drivers from...
DOS games arent going to work too well in Win2k/XP. For best DOS results, use Windows 98, and the VXD drivers for the CMedia card. Pretty much however far you...
... Good question :) I've unsubscribed the sender of that spam, hopefully (crossed fingers) the group isn't going to suffer similar spam messages of that sort...
Hello everyone and Happy New Years! I just joined this group. I received and installed my Zoltrix Pro6 sound card yesterday. I'm running Win2000 pro. The...
I finally got my Zoltrix Pro 6 up and running (digital and analog) after loading the newest drivers. I am about ready to start dubbing MDs to my PC. But,...
the audio cable must be hooked up to play cd's through your speakers from the cd through your sound card... you can listen to cd with a headset in the jack on...
On Fri, 4 Jan 2002 17:26:23 -0800 (PST), ye dyde bashe out the ... If you have been playing CDs successfully without any of these wires, then you don't need...
Rich Hanson
richard@...
Jan 6, 2002 8:32 am
555
Hi, guys! I was looking for an inexpensive way to connect my PC and my A/V receiver and I've found that CMI 8738 based cards is what fit me. Unfortunately, ...
i would just like to point out that i believe its Win98SE or later, (not the original Win98) - because playing CD audio over the system bus requires WDM ...
On Sun, 6 Jan 2002 14:00:46 -0600, ye dyde bashe out the followinge ... Yes, I think you are right - I don't have the option here and I'm not using WDM...
Rich Hanson
richard@...
Jan 7, 2002 7:12 pm
558
Thanks for your assistance. I went ahead and installed the cables (digital from my CDRW, analog from my DVD-ROM). Another stupid/newbie question. Can I hook...
yOU CAN TRY BUT i'M NOT UP ON THAT TOO MUCH yOU MAY WANT TO HOOK THE OUTPUT FROM YOUR CD TO THE I/P OF THE SOUND SYSTEM INSTEAD The output from the cd & dvd...
Ideally your receiver will have an optical (or coax) input. You can feed the Zoltrix's digital out directly to it when playing a wave file. If you want that...
Hello I'm very new to this so is there anywhere around London I can buy a cheap sound card that has opto s/pdif I/O that reads 44.1k in both directions ? I can...
Hi all, and greetings from Australia. I'm mailing you to know why my CMedia-based soundcard - a 8738-based Leadtek "6xSound" card - nobbles some other...
Hello I wish i'd read your letter before I parted with £10 this week end! I just bought an ARTIS 738s1 and sure enough it has the non SPDIF SX chipset GRR! ...
** Reply to message from "agarthan_at_work" <agarthan@...> on Mon, 14 Jan 2002 06:23:24 -0000 ... S/PDIF streams usually won't respond to volume control....
Is it possible to have SPDIF streaming output from microphone or line- in in 833x chip cards? I couldn't do it myself. Does anyone know a device (like MDs or...
Any MD deck which can be put into monitoring mode (and has the necessary I/O, of course) will do this - latency will be very low (around 3-5ms at most, I...
Hi, ... http://www.ntonyx.com/vac.html ... I've tried too many to mention. :) I gave my reference 8338 away, but I currently have two good old Audio Excel ...
Hi, I'm having problems getting my soundcard to work. I'm using this Typhoon card (Acoustic 4 Soundcard 3D). No hardware conflicts and already used all...