concordion : Concordion

Discussion about the Concordion acceptance testing framework.

Re: #set a map instead of var Concordion works fine for black-box testing. The point is to write tests in terms of single, simple required behaviours and then use the fixture code to set-up Posted - Tue May 1, 2012 3:12 pm	David Peterson dpeterson72 Offline Send Email
Re: #set a map instead of var Thanks for quick reply. I agree with keeping the test simple. However I am trying to use concordion for system (black box) testing (as opposed to unit test). Posted - Tue May 1, 2012 2:58 pm	bin_mil Offline Send Email
Re: #set a map instead of var I would strongly discourage this kind of complexity in the specs as it's likely to be a maintenance headache! Try breaking your tests down into a lot of small Posted - Tue May 1, 2012 1:59 pm	David Peterson dpeterson72 Offline Send Email
#set a map instead of var Dear all I am new to concordion and I am searching for an answer to the following question. But not real luck so far. I hope someone is this group can give me Posted - Tue May 1, 2012 1:45 pm	bin_mil Offline Send Email
Re: Run setup() once before entire set of Concordion specs have run Hi Ronnie I've used code like the following to allow test resources to be discarded gracefully, both when the tests are run standalone or in a suite. public Posted - Tue May 1, 2012 8:51 am	Nigel Charman nigel.charman Offline Send Email
Add concordion to your personalized My Yahoo! page What's This?

Yahoo! Groups