This is a list of factors expected to affect how fuel line magnets can be used. This info will change over time..... 1) what affects the fuel in the line is...
diy_magnet_use@yahoog...
Feb 1, 2006 12:59 pm
186
This is a FAQ for the DIY magnet use group at....http://groups.yahoo.com/group/diy_magnet_use/ It will be modified over time as new ideas and info become ...
diy_magnet_use@yahoog...
Feb 1, 2006 12:59 pm
187
Okay, here's what I'm thinking: Take a toroid coil or wind one yourself by getting the toroid and wire at your Amateur Radio store then slip the rubber or...
Several people have mention using electromagnets and various frequencies..... etc... directed at the gas flow. Don't know of this would work...don't know...
This is a FAQ for the DIY magnet use group at....http://groups.yahoo.com/group/diy_magnet_use/ It will be modified over time as new ideas and info become ...
diy_magnet_use@yahoog...
Mar 1, 2006 12:19 pm
191
This is a list of factors expected to affect how fuel line magnets can be used. This info will change over time..... 1) what affects the fuel in the line is...
I've posted a new text file in the file section labeled as "MPG.txt". This has to do with easy DIY mods and methods for increasing the mileage of your gasoline...
This is a list of factors expected to affect how fuel line magnets can be used. This info will change over time..... 1) what affects the fuel in the line is...
diy_magnet_use@yahoog...
Apr 1, 2006 11:20 am
197
This is a FAQ for the DIY magnet use group at....http://groups.yahoo.com/group/diy_magnet_use/ It will be modified over time as new ideas and info become ...
diy_magnet_use@yahoog...
Apr 1, 2006 11:20 am
198
I have recently found the magnet that I will use for my first experiment with magnets and fuel economy: its a 2-inch round disk magnet that was once a speaker...
My apologies to everyone on this list! I was so excited I grabbed the last list message to reply to just to get the address right that I then forgot to...
Imagine a device about five inches in diameter by ten inches long, with a tube running from it to a bolt on your engine. Your engine is running, but your fuel...
Not too sure what the flux field would be like in the center of that magnet...best bet is to try to get the magnet surface as close to the fuel line as...
My magnet is in place with the fuel line running through its center hole. This magnet came out of a 30-watt 8" oblong speaker because I can't find retail...
If you are near a Radio Shack...you can find the large ceramic magnets for not too much. My testing (limited) showed that they did about as well as the neos...
This is a list of factors expected to affect how fuel line magnets can be used. This info will change over time..... 1) what affects the fuel in the line is...
diy_magnet_use@yahoog...
May 1, 2006 9:50 am
205
This is a FAQ for the DIY magnet use group at....http://groups.yahoo.com/group/diy_magnet_use/ It will be modified over time as new ideas and info become ...
diy_magnet_use@yahoog...
May 1, 2006 9:50 am
206
I placed this gas saving device that I got from www.GasSaverUSA.com for my 98 Ford Explorer V6 engine on the fuel line. I have been driving around for the...
I'm thinking that you could suck good vapor into the vacuum under the carburetor/throttle body... I am planning to use the same vacuum line tapped off the...
This is a list of factors expected to affect how fuel line magnets can be used. This info will change over time..... 1) what affects the fuel in the line is...
diy_magnet_use@yahoog...
Jun 1, 2006 12:25 pm
210
This is a FAQ for the DIY magnet use group at....http://groups.yahoo.com/group/diy_magnet_use/ It will be modified over time as new ideas and info become ...
diy_magnet_use@yahoog...
Jun 1, 2006 12:25 pm
211
Might finally have the raw gas issue solved. Seems to happen mostly when the car is started up cold...run for a minute or so and then shut off and allowed to...
This is a 6 month report on the results of using magnets on water lines. Generally I have some neo magnets on the main water line (copper) and some extra...
This is a list of factors expected to affect how fuel line magnets can be used. This info will change over time..... 1) what affects the fuel in the line is...
diy_magnet_use@yahoog...
Jul 1, 2006 10:17 am
214
This is a FAQ for the DIY magnet use group at....http://groups.yahoo.com/group/diy_magnet_use/ It will be modified over time as new ideas and info become ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
