John, Any idea when the CAM software will be able to cut a Z profiled slot with the cutter depth controlled by depth of cut? At the moment the depth of cut...
A work around would be to cut and paste the Z profile slot command in the Program operations window a number of times then edit each event so that the Z start...
Andre, Many thanks for the prompt response, much appreciated. I had considered the solution you suggested as a work around but the machining time is horrendous...
... Ah, well ...... good old English architectural units have their uses too .....Tell a builder to lay his bricks to thou's and you get a builders response! ...
Hi Folks I've hit a snag when tring to get a centre drill to do its job. Using canned cycles I can change the depth of the holes but it completely ignores what...
In a message dated 5/31/2006 9:00:05 A.M. Mountain Daylight Time, steve_vagg@... writes: Using canned cycles I can change the depth of the holes but it...
No, I tried all options, but if I frig around with the centre drill setup it seems to change, something to do with the max cut depth I think steve ... From:...
Hello Steve, I've tried to duplicate your problem but can't, when I change the depth on the canned cycle it changes depth machined. Perhaps you could send me...
Jim Is the problem repeatable, i.e. does it Always happen with the same files. Send me a copy of the files in question (email zen11777@...) and I will...
Michael, Here is the file, It appears to happen all the time. it has happened with other files in the past but as they were simple to draw i just redrew them. ...
Jim You need to send the email directly to me, Attachments are not carried on group mail. Email Address shown below. Michael Dolphin Cad Cam Systems Ltd _____ ...
... I'm on 9.1.1010 It would be nice if there was some indication of what version it is instaed of the generic Setup.exe file that could overright something...
... Correction , just found 9.1.1012 on the web but the help about stops at 9.1.1009 so no idea what's in it. Mike and John, this does address the pocket...
John, where did you get 1012? I just did a download of the CAD-CAM and still got 1011 that I had before, although it screwed up the release note file which...
The current version at the official Dolphin web-site is 9.1.1011. Setup has always had the Modify / Repair / Delete options, but Windows Installer service does...
I exported a dxf file from Rhino3D this morning (AutoCad 12 format using simple entities) and imported it into PartMaster CAD and I was able to snap to the...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
