This is a little tricky to describe but the problem is really very
straightforward. For some reason my old 1200 has a really annoying
habit of getting itself out of position. In other words, the print
heads often don't park at the right end where they're supposed to ,
they sit wind up stopping somewhere along the print track where
they're not supposed to. Once this happens I have to shut it off,
manually reposition the print headss and then turn it back on. I
usually have to then clean the print heads .

It''s been getting worse and I'm wondering if anyone might know how
to fix this without resorting to replacing the printer.

I have a Niagara Continuous Inking System set up on it but it doesn't
appear that that is the culprit. There is no unusual drag being caused
by the feed t tubes. I've been using this setup for a number of years
without any problems until now.

Any suggestions would be greatly appreciated.

jwynn80@...