I can't figure something out about the 7000...it will only respond to bank change messages when they are coming in on channel 1, no matter what the rest of the...
Mike the 7000 works correctly as per the info you have below. The unit will ignore Bank Changes messages if you are sending the same value of the current Bank....
Well, I figured it all out. If you set your 7000 to channel 11, and turn Omni off, and transmit Bank CC#0 on channel 11, then everything works fine. However, I...
Maybe I've missed something, but I examined those presets, and don't they function off of the global tempo? In other words every time you load them they will...
I'm currently using version 1.99.2.0 (posted April 2003). I've tried using 2.0B1 and prefer it overall, but the bugs in the multitap and multitap2 delay...
Trey you need to observe how your tap tempo and presets work. When a preset is stored, it also saves the current dly/lfo/verb decay settings. If you reload the...
There is no set date for the new Vsig release as many projects are on_going (pedals, etc.). It shouldn't take too much though. We'll look into the Multitap and...
can you use the orville with vsig just thru midi or does it need serial too? thanks and regards bob ... [Non-text portions of this message have been removed]...
luca, thanks for your input bro. italo also.. i must have a levels issue beacuse im not pushing the input at all, no lights? im going to check the levels...
If you have a serial port on your computer, I HIGHLY recommend using it instead of midi. If you don't have a serial port, but do have a USB port, you could...
Yes. Definitely a very good point. On a computer bus MIDI seems to have a max bandwidth of 31.25 kbit/s = 3.9 kB/s, while the serial port can reach a max of...
Hi Italo, I was wondering, if you can answer with certainty, whether the Eclipse outputs a signal that is completely identical in phase with the input. I...
I know that the speakers in the reissue Fender Bassman were wired up weird. One of the tricks to getting a better tone on that bassman amp was to flip the...
I just noticed when I do a "Get Patch" on certain Patches in the H8000, they show up in vSigX in one stretched out little column :P For example Heen 6113 looks...
If the phase wasn't the same, you'd either get complete cancellation (i.e. silence) or a very thin sounding comb-filter effect if you did a 50% mix of input &...
thanks guys - i stopped using my mac for vsig and instead booted up an old pc - its so much faster than midi!! ... [Non-text portions of this message have been...
Bob you can use any computer these days, adding a serial port w/a USB to COM converter. I have it on PCs and Macs. There are many brands and can be very cheap....
hi, i did as you suggested and added a summing mixer to the algorithm i use (blues heart). has a rehearsal last night and it sounded fantastic! thanks again...
Ok! When 2 channels are collapsed to a mono single output, using the MIXER module, the 2 channels levels should be set no higher than -3dB. Sometimes they...
I see in the user manual that user congigs not only set the I/O blocks, but also the DSP routing as well. From the User Manual: "4 Channel parallel routings. ...
Phil Routings and Presets are strictly correlated by the number of inputs and outputs. Obviously to listen to 5.1 presets, you should load a 6 channels...
Colin, The flattened representation of your patch is actually the result of vSigX's re-positioning algorithm. The algorithm I used is a recursive trace...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
