Hello,

I bought a FS2 unit with Astromeccanica motors kit (Sanyo-Denki
103H548-0440) on a GPD2. I'm experiencing a problem with the PEC
correction tool. Each time a "learning" is finished and the PEC is
on, the corrections performed by the PEC are bigger then the ones I
performed during the learning procedure, and the referencing star
moves a lot in the field of view following the wrong inputs of the
PEC. This happens always, both with the PECdecl parameter on yes or
no. With the PEC on, is impossible to make an exposure of even few
seconds.

Can you help me? At this time I use the scope with the PEC toll off,
with severe limitation on the maximum unguided exposure time.

Thank you.

Best regards,

Gianluca