Hai guyz... Sorry for the late reply.. A bit busy though... For ur question Roger... I only find out that when downloading a command into the board then only...
Hai guyz... I just discovered a new problem with the gogomonitor 3.1.0... 1) When ur editing/import/export/create new stuff on the sensor lab.. It kinda hang...
If you are referring to the new gogoboard 3.5. It is not publicly released on the site yet as we are doing some final testing. But I don't expect much to...
members have full, unrestricted access to the site for the period of their membership. We do not charge to download the free listed on this site (even when we...
hey roger..... you are the inventor of the microworld too right?i" totally freakin' out right now for my presentation.....:-(how are you?prepare to make a...
hey roger.....can you do me a favour?do you know a film called an inconvenient truth?if you know it and you have it could you sent me the copy of it?i have...
hi zafri....i've download the procedures for the gogoboard.but when i try to test it,the output didn't work......i push the active button but it didn't even...
hi zafri...i have download the proceduers for the gogoboard but the output didn't work...i push the active button again and again but it still didn't working.....
Hi there, Here are some gogoboard news for you. [1]. GoGo Board hardware and firmware source are now available. [2]. Building and selling GoGo Boards [3]. The...
thank very much for hard work. i had downloaded a source code, learning ... thank very much for hard work. i had downloaded a source code, learning On 4/11/07,...
hey roger.....i found a new problem....when i connect the gogoboard with the gogomonitor,the output and the active button were damaged.....when i disconnect...
i am building board, and i am stuck at steap2 only pwoer led is on and there is no beep and why are there three holes for crystal, but cristal have only two...
can you snap a photo of your board and send it to us? This could help us see what is going on. The middle hole of the crystal is optional. Some crystals have...
Hi Satish, I don't see the picture. Did you forget to attach it? -roger. ... -- ================================= Arnan (Roger) Sipitakiat Future of Learning...
see in the photos of yahoo gogoboard group ... From: Arnan (Roger) Sipitakiat <arnans@...> To: gogoboard@yahoogroups.com Sent: Monday, 16 April, 2007...
this is my second attempt with different board but same component as pevioussame result ne beep only power led is on what are the simtumes of no or bad...
Hi Satish, Here are some things to check: 1. Check all soldering points. You should solder all the pins of the components even if they are not used. I.e....
there is no firmware in chipmonly bootloader , what are the signs of no boot loader are the all trackes correct according to you, is there any short circuit? ...
i have done you suggetion but no result when button pressed only power led is on can you send me a gogoboard of any ver, i will pay for it can you suggest me...
update i am done with you suugetion but same effect when ipresed run button run and user led are still off i was descovered that i was giving 15 volt 500mA i...
15 V should be okay. The power regulator my get very hot but it should still work. Are you sure you burned the bootloader to the PIC? If you did, may be there ...
yes there is 6 volt on circuled area , this reading is due to faulty multimeter because it is old and analog did you get pic if not i am posting on yahoo...
