Hello all,

How can I show the state of all the security sensors I have setup for
heyu? When I issue heyu show sensors I get the following output which
doesnt seem to contain their alert or clear status:
K1 DS10A Kitchen_Door battery OK, active YES, tstamp 07/09 09:02:56
K2 DS10A Front_Door battery OK, active YES, tstamp 07/09 09:01:02
K3 DS10A lv_room_win1 battery OK, active YES, tstamp 07/09 08:58:36
K4 DS10A lv_room_win2 battery OK, active YES, tstamp 07/09 08:37:58
K5 DS10A Kitchen_Window battery OK, active YES, tstamp 07/09 08:39:29
K6 DS10A Bsmnt_Stair_Door battery OK, active YES, tstamp 07/09 08:32:39
K7 DS10A Bsmnt_Rear_Door battery OK, active YES, tstamp 07/09 08:47:48
K8 DS10A Bsmnt_Front_Win battery OK, active YES, tstamp 07/09 08:50:52
K9 DS10A Garage_Door battery OK, active YES, tstamp 07/09 08:16:00
K10 MS10A Bsmnt_Motion1 battery OK, active YES, tstamp 07/09 08:32:25

However if I issue a heyu arm it always warns me of what sensors are
in alert state, so I would think I could display this info from a
command as well?

thanks,
Jeff