My 3325A went on the fritz. Does anybody happen to have a repair manual? It's not available from Agilent and I can't seem to find one. It appears something is...
does anyone have the specs or a working sub for this diode removed from an HP-181A in the high voltage supply, made by VARO number as on the diode is 1901 0341...
David, This diode would be a high voltage, low current, fast recovery diode. This diode consist of several diode junctions connected in series. There will be...
... diode. ... There will be approximately 0.7V volts forward drop for every 800- 1000V of ratings. For example if this is an 8 kV diode the forward drop will...
Good day all - I have an HP 5342A with Option 2. My problem is that the displayed amplitude for the low frequency input reads about 10 db high. I have traced...
Thanks to Jos, the HP 3325A service manual is now at http://www.ko4bb.com/ham_radio/Manuals Thanks Jos for your patience!!! Didier KO4BB =====> Hello Didier, I...
... Note, this is the same version that is on John Day's web site: http://www.nm2.org/files/HP__3325A_OM_SM_1.pdf For those who haven't downloaded it, it's low...
one of the problems in the 3325A is loose screw, at this instrument the grounds closure at varius points of each pcb is done thru the screws holding the pcb to...
Guys, thanks for helping out with the manual. John Barnes also emailed me a copy. I found a bad cap in the VCO and now things are working much better. There's...
Hi, friends. I've been offline for the group for a few months, but wanted to give you a brief update around Agilent and HP manuals. We've found lots of...
Hello Dave, thank you for your effort which is much appreciated. Is it possible to publish a list of manuals newly added to the Agilent site? Otherwise I will...
I have a problem with my 4195A spectrum. He worked fine the other day, and switching it on the next day iit always beeps and gives Overload on R1 or T1 or...
3398
vi-west475@...
Apr 4, 2006 1:10 pm
meet-up with guys and girls in your local area http://www.lookatthatnow.info/rufb i did...
I never found anything with schematics and ended up spending a few months intermittently re-soldering every suspicious-looking connection on the processor and...
Does anyone here have login info for the Agilent ftp site? I have several manuals to upload but the login I got from Dave does not work. Best Regards, ~petev ...
If anyone has a cosmetically ugly or non-working HP 8656B RF Signal Generator and you are willing to let it go, I would be interesting in discussing a fair...
They did sell a schematic manul it was about $500.00 for it when it was sold. We have a closely guarded copy and it gos into deep detail. Dan Tom-WB3AKD...
Hello, I am writing to you because I didn't find any information about a DIY differential probe on the web. Or, maybe, I didn't use the right words in my...
3406
Mwcpc4@...
Apr 5, 2006 2:38 pm
A 4193A Vector Impedance Meter was donated to our museum, without probe. It does not fit our collections policy but the curator found out that one is on Ebay...
... The $8450 one has been listed several times. The seller always tends to list high and sell very little. Recently one in otherwise working condition but...
And if you check the listings of the high high priced seller, you will notice he has no photo of this item. In the past they have listed items as "fully...
