I've been looking for a place to find a credit card. Here it is. My credit was really bad but, they where able to appove me! Check it out! Click on link Below!...
Can someone remind me what the state of the art is re: chunked POST? From what I can see, it's allowed, but there's not a good interoperability story with 1.0,...
Mark- I can't speak for the official position. The primary interoperability problem is due to CGI 1.1 (and earlier). CGI REQUIRES a CONTENT-LENGTH. Some...
91
Alex Rousskov
rousskov@...
Jun 11, 2002 4:17 pm
Mark, FYI: Since supporting chunked encoded _messages_ is a MUST, our HTTP compliance test suite has test cases that use chunked _requests_. So far, none of...
Thanks. So, from a client perspective, they might expect any of the following behaviours when sending a chunked POST; a) success b) 411 Length Required c) 5xx...
93
Alex Rousskov
rousskov@...
Jun 11, 2002 5:07 pm
... e) a malformed/invalid message reaches the server (proxy corrupts message body and/or headers because it does not understand what is going on); the server...
94
Patrick McManus
mcmanus@...
Jun 11, 2002 5:14 pm
[Alex Rousskov: Tue, Jun 11, 2002 at 11:07:10AM -0600] ... f) 100 continue -Patrick...
95
Alex Rousskov
rousskov@...
Jun 11, 2002 5:24 pm
... g) nothing (i.e., the recipient [erroneously] waits for more data, without sending 100 continue) Alex....
h) 413 Request Entity Too Large. -Carl Alex Rousskov <rousskov@...> 06/11/2002 11:24 AM Please respond to http-compliance To:...
97
Alex Rousskov
rousskov@...
Jun 12, 2002 12:37 am
Hi, I cannot decide if the following is a MUST-level requirement (i.e., its violation prevents RFC 2616 compliance, even conditional): 13.10 Invalidation After...
98
François Gournay
francois.gournay@...
Aug 5, 2002 3:23 pm
We have developed an HTTP Proxy and I need to test that it is HTTP 1.0 and 1.1 compliant. Is there any automated tool to do this? Thanx in advance. -- Francois...
99
darin@...
Aug 5, 2002 4:39 pm
François, I'm not aware of any generic tool available for testing HTTP/1.x compliance, but I would like to point out that there are some aspects of HTTP/1.1...
Hi, We have a fully automated HTTP Complaince Test Tool, designed to carry out both 1.0 and 1.1 specific tests on a HTTP Proxy and thereby determine the level...
101
Alex Rousskov
rousskov@...
Aug 6, 2002 2:57 pm
For the record: Co-Advisor, another fully automated HTTP complaince test suite is available at http://coad.measurement-factory.com/ You can use the on-line...
HI gayathri, can you send me details about the HTTP complaince test tool, I am planning to test my proxy with it, I am specifically looking at security issues...
Hi, I'm writing a minimal HTTP/1.1 origin server and I'm striving for conditional compliance. I have a couple of newbie questions about whether Conditional GET...
104
Alex Rousskov
rousskov@...
Jun 3, 2003 4:58 am
... There is no clear/single MUST that says "the server MUST support a conditional or partial GET", I think. However, you may still get a practical answer to...
... at ... must ... Thanks for your reply. Two of my primary design goals are conditional compliance and simplicity, so I'd like to be able to reduce this...
106
Alex Rousskov
rousskov@...
Jun 4, 2003 10:33 pm
... Except for If-Match: * ... Except for If-None-Match: * especially for non-GET/HEAD methods. ... In general, your server may be serving content that was...
Hello again, ... Well, it took me a little longer than days :) (Actually, I just hadn't had time to work on it over the summer.) I think I have come up with an...
... if If-Unmodified-Since is present respond with 412 Precondition Failed ... ...in other words, pessimistically assume the resource has changed. -Chris ...
Hey ho all, I'm currently pruning 2616 down to a list of the actual requirements, but it occurs to me that someone must (MUST) have done this already. Can...
112
Alex Rousskov
rousskov@...
Jan 29, 2004 5:20 pm
... A list of MUST-level requirements (cross-linked with the RFC 2026 text and test cases, where applicable) is a part of the Co-Advisor test suite: ...
Hello, I've noticed the following behaviour between ie version 5, 5.5 and 6... If the browser makes a GET request that returns a HTML page that references...
Hi all, we have been developing a HTTP/1.1 server that will support cgi scripts. please any body let me know how should i get the output of a cgi or perl...
115
Alex Rousskov
rousskov@...
May 23, 2004 4:19 am
... The exact solution would depend on your programming language, libraries you can use, operating system, desired performance, and a set of features you want...
Hello, We have been developing a Server with considering only MUST requirments. but we r facing a problem to input and get output from a CGI script without...
