Hi, Do you get parity errors? How much is the buffer length ? Regards, K.Narayanan ... From: embedesigner_puneet To: interfacing@yahoogroups.com Sent:...
HI, The global varibale must be declared in one and only one file without "extern" identifier and in all ather files with the "extern" identifier. this is 'C'...
Hi, When you get the signal that data is received at the port, wait for few miliseconds before reading the entire buffer. Hope this would solve your problem. ...
Hi, I found your website and thinked maybe you could advice or help me with little problem I have with my DAQ card. I have parallel port DAQ card which have 8...
Hi This is wat axactly i tried, i made a thread Thread.Sleep(1000) then i fetched the data from the receive buffer n it worked, right way Thanks 4 d advice ...
From: amin_chetan To: interfacing@yahoogroups.com Sent: Saturday, September 09, 2006 3:12 PM Subject: [interfacing] hi ... Yah, It is true that with every...
hello everyone!! i am trying to read data from the hard disk using the base address of the hard disk. can anyone tell me how to do it?? actually i am trying to...
Very Busy at this time but if someone post a problem that is in a hard field to define I will respond! I would like to see people keep the teamwork up at all...
DO NOT HIT Reply Button, your resume might go to all members of the group, Reply to : terrafirmapune@... How to apply:You can directly upload your resume...
I am part of a team that has developed an AT89c52 controlled hand-held device for collecting data during surveys and it stores the data in an EEPROM. Now I...
Hello Friends ! I am doing a project in my Institute. I am using IR sensor in this for counting. When there is no hurdle between IR tansmitter nad receiver...
http://tinyurl.com/rl9gu check the above website to get the complete list of websites to get online works outsourcing work,make money online, freelancer works...
Hi, We are a Sunnyvale California based organization with offices in major parts of the world. Fortuna's Wireless & Telecom competency center is located in...
Hello Try to use the values of the drop as your switch as - insted of + values to the switch counter. The change will be consistant and give good resaults Mike...
hello to all first i have some problem in DSP processors TMS320C6714 KIT basically i want to create a squre wave at constant time period and second one is...
Hi, Try putting a buffer between the sensor's output and the op-amp. Do you use the op-amp as a comparator, or as an amplifier to raise the voltage level? If...
The RS-232 Protocol Analyser software at beyondlogic.org does not work above com port 4. It there a patch to work with 5, 6. etc??? Some of the new USB/232...
HI There are IR sensors availablein 3 pin package which can be used to get direct TTL output.. these are mostly used in TV for remote controller sensor thanks ...
Hi! i read about AT Command and i found (AT*EAPP=6) that can support sending MMS but in this command there is no destination (E-mail address or telephone...
I am an idiot. My computer crashed yesterday and I lost all my important information because I did not have any backup. I found some Data recovery links which...
Hi! i read about AT Command and i found (AT*EAPP=6) that can support sending MMS but in this command there is no destination (E-mail address or telephone...
Hi! i read about AT Command and i found (AT*EAPP=6) that can support sending MMS but in this command there is no destination (E-mail address or telephone...
Hi! i read about AT Command and i found (AT*EAPP=6) that can support sending MMS but in this command there is no destination (E-mail address or telephone...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
