Moses wrote:
> Dave I assume it doesn't make a difference if I turn the tube
> clockwise or counter clockwise? 

No this is a last ditch effort to try something different, when every thing else fails that all the experts have suggested. It has worked for me. It assumes you were unlucky enough to get aligned perfectly out of phase. The 7 degrees will insure you miss this nasty alignment that can kill that gaps voltage on a first time charging of the can.

> On your energy perception, can you tell the difference between
> different types of energy such as Microwaves, Infrared, Ultraviolet
> etc. What is your perception when you are in the presense of Alpha,
> Beta, or Gamma particle producers? How about you experiences with
> getting a dental or medical x-ray?

I do not think the pineal senses are sensitive to EM much at all, the pineal is pea sized and has no metal, but uses calcite crystals. The tounge gets the EM better. You will get the taste of a battery. Body sensitivity is generaly to vibration. The trick is to realize how high this can function for you. Most people can both hear and feel a very low vibration in the gut. As the frequency rises, the vibrations move up the spine to the head. Over about 100 Khz they center in the center of the brain. Over about 30 Khz they stop being heard with the ears, and only the pineal senses them. Touch can now help to lower the resistance from vibrating object to pineal. Playing with a bismuth core coil can allow you to slowly raise the frequency, and expand your senses a bit.

> If you can percieve conventional electro magnetic radiation, how in
> your perception does the energy produced by our Joe cells differ?

The cells are vibration, not EM.  But there is a link. We discovered with resonant rods and on Joe Cell feed tubes to the engine especially where they are cut on a node, there is a percent value for any resonant vibrating rod between the nodal peaks of vibration where a pin point voltage will appear. If you locate a strong node where all the EM drops to zero, the EM noise floor drops away, now slowly slide to one side or the other, you will find the voltage standing there using an AV plug. I have a calculation for this distance if the resonant distance between 2 nodes is known. The ratio seems to be a constant.

http://magnetism.fateback.com/925hz.htm

At the bottom of this document the red length shows the actual measured numbers. This ratio seems constant for all the resonant rods I have tested. Cutting a tube right on the E field node will create a charge on the entire surface of the tube in this case. You have to grind to very good accuracy and the voltages are small until you drop them in water.

I think the JC gaps are doing similiar, as the voltage seems to just come right up out of the metals themselves.

-------------------------

Cleaning water with a JC:

Since I move in here, the water has always been rather nasty, copper pipes in the house and much sediment in the toilets over time.

4 days ago I connected a JC up to my houses copper water system. Also placing a ring of magnets to keep the energy from leaving out the main feed and on the furthest toilet in the house. The magnets seem to draw the energy along the copper pipes better. Center tube of JC is connected between the magnets on the copper and charges up all the copper between them.

This is the 4rth day and the water is not only clean, there is no smell of clorine or flouride, and it tastes so good I am considering giving up diet coke!

Tonight Dyan noticed even a little bubble action in the water left setting on the counter, they are very tiny bubbles indeed!

Stage 3 water from the tap??? Don't know yet.

This is the first time I have drunk anything having to do with JCs. After reading up on the water vortexing systems and Ormus theory, this was a natural thing to try. Very glad I tried it, because it is normally impossible to keep water clean in copper pipes. But I always noticed that if the JC is polarized correctly the water stays very clean.

If any are intrested I have made diagram of my setup.

Dave L

> Just currious,
>
> Moses
>
> --- In joecellfreeenergydevice@yahoogroups.com, "David Lowrance"
> libra_spirit@ wrote:
> >
> >
> > Some of my perceptions on increasing the energy of the cells,
> >
> > Consciousness:
> >
> > Study the two slit experiment. Look for the act of perception, and
> how
> > it effects energy propagation. Perception alone can change an energy
> > wave into a new single point radiant field, radiating a new wave
> from
> > the point where perception crosses the path of the omni directional
> > wave. The energy transfer is so perfect we say the photon has moved
> to a
> > new location at c velocity. Yet the new photon now starts to become
> a
> > wave again at that location. Is this not energy transfer by
> percpetion
> > alone?
> >
> > Now consider the sensitives all turning away from the public science
> > dissection process, as it only invalidates their experiences. They
> are
> > viewed as deceptive magicians, hiding something physical.
> >
> > The scientist follows Joe around, captivated by his "special power
> > supply, " and trying new circuits, while Joes "conscious focus" his
> > "perception" is not on the power supply. What is different between
> Joe
> > making a car run in only days with almost any cell, and hundreds of
> > people emulating him with elaborate degausing coils, and other water
> > conditioning systems, and getting far less results? I would offer
> maybe
> > he has learned how to percieve, such that energy moves to the point
> of
> > his focus. The cell has the ability to hold this energy and build
> it up
> > if it only meets a threshold of accuracy.
> >
> > Science deals with energy, as though it cannot be manipulated by
> > conscious perception. Science even tries to deal with the two slit
> > experiment using meters, and alienation of the human focus. Cold
> > disconnection from the experiment.
> >
> > If you want to see and feel a torsion node, stop looking at the
> meters.
> > Look for the nodes, feel them, and they will appear. They will
> appear,
> > strong enough to interact with a point lazar beam.
> >
> > Moses,
> >
> > One other thing you can try, to get the can to flip its polarity,
> turn
> > it by about 7 degrees with respect to the other tubes. Now charge
> it up
> > again with water and see if it will stay flipped after 24 hours.
> During
> > the 24 hours use low voltage only, no bubbles. If you get the phase
> > correct very little energy is needed to flip the spin on the can.
> >
> > When a coherent field forms on the JC, it will only radiate in 24
> > directions, these will be burned into the tubes and alter their
> natural
> > pattern. Until the pattern is shifted on the tubes you do not want
> the
> > water boiling up, as the coherent field will be lost that is
> altering
> > them.
> >
> > ----------------------------
> >
> > My latest exepriments with a 6 pound copper sphere filled with
> sand, and
> > a 6 pound sack of flour have revealed that if one becomes sensitive
> to
> > look for a Star tetrahedron vibration, it will lower the weight of
> the
> > object during the perception experience. This is equivalent to party
> > levitation, but can be done with only one person using the sphere.
> >
> > There are people that can lift the sphere now and toss it about as
> > though it were not 6 pounds at all, but very light. Hand them the 6
> > pounds of flour and they cannot believe that if we place both on a
> scale
> > they weight the same. Once the person connects with the spheres
> root of
> > 3 vibration it feels light to them. This is very similiar to how a
> Joe
> > cell feels when fully charged, in that the car seems to loose its
> > inertial momentum qualities.
> >
> > http://magnetism.50webs.com/Math.htm
> > <http://magnetism.50webs.com/Math.htm>
> >
> > Sincerely,
> >
> > Dave L
> >
>