I use the variac and bridge rectifier to prep the water. About 1 amp of
current.

For the cell, I'm now using a 555 pulser circuit running at 5 Hz to spin it
up. No need to push a high current through the cell to activate it.

In the car we just used the battery voltage and a pot to reduce it slightly.
Less than 50 uAmps.

Bernie

----- Original Message -----
From: "cellery97" <no_reply@yahoogroups.com>
To: <joecellfreeenergydevice@yahoogroups.com>
Sent: Tuesday, January 06, 2009 1:52 AM
Subject: [Joe Cell Free Energy Device] Re: bernie charging


> no mate theres no scum i do passivate everything.
> my question was in regards to the water preparation proecedure,
> particularly the voltage and duration times of voltage application,
> and the electronics and hardware your using.
> i had the feeling that i had read your recent posts that you have
> altered your method.(i couldnt seem to find those posts again) and
> have yet to updaate the charging document. is that right?. if so wats
> the new process youve come to favour, or maybe im wrong? , do you
> still charge with a variac and a bridge rec. and small filter circuit,
> then adjust to 1 amp?
>
> --- In joecellfreeenergydevice@yahoogroups.com, "Bernie"
> <bernieheere@...> wrote:
>>
>> Are you still getting brown scum? All we're doing is oxidizing out
> the impurities.
>>
>> Did you passivate the plates. If not, the scum will never stop, as
> more iron will come out of the plates.
>>
>> I use a simple 555 circuit running at 5 Hz connected directly to
> the JC after the water is prepped. It seems to work a little bettter
> than direct DC, but DC does work.
>>
>> Bernie
>>
>> ----- Original Message -----
>> From: cellery97
>> To: joecellfreeenergydevice@yahoogroups.com
>> Sent: Wednesday, December 31, 2008 11:58 PM
>> Subject: [Joe Cell Free Energy Device] bernie charging
>>
>>
>> gday bernie, i hope you could please tell me what im doing wrong
> in the preping phase.
>> ive got a smack type plate arry submersed in a 5 litre stainless
> container with the no lid.
>> my power is 240 v run through as torodial transformer that has
> two sec taps at 50v each. i combine the two secondarys and make 100v
> ac. then i run them through a bridge rec. then through a simple
> parralell circuit comprising of a 350v 1 micraF cap then a 10w 10Ohm
> resistor. i dont have a cro so i dont know how clean that comes out.
> then i run three or four 20 minute charge cycles through the water
> filtering inbetween and allowing to cool. almost straight away the
> surface is covered with bubbles and i can no longer see the water.
> around 16amp is pulled wich is a bit high, but i monitor the water
> temp with a laser temp gauge so it doesnt get to hot.
>> some times i piggy the positive wire from the smack plate array to
> the stainless container creating another anode around the outside.<
> br>i suspect your going to tell me to drop the amps and the volts. but
> to what and how.
>> also arent you messing with pulse charging now. how can i acheivve
> that.
>> appreciate any answers from anyone on this.
>> nath
>>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>