I just uploaded V2 build 1994 to http://www.grzsoftware.com/v2dl.php . The following changes wre made: -Fixed 2-side machining region to account for tool...
I just uploaded another V2 release to http://www.grzsoftware.com/v2dl.php . Yesterdays release had a bug in the shaft interference code that I had to fix....
I don't know if I'll ever be able to explain it, but that seems to be the pattern. Whenever there is odd crashing that didn't exisit before, the next release...
Oddly enough I am still having the crash problem when creating the tool path. Randy _____ I've stopped 13,078 spam and fraud messages. You can too! One month...
Robert, Did you let a bug into 2017? When running the same stl (338452 faces, metric mode, on a 3.0 gig 1024meg p4 using win98se) the first Z offset took 610.9...
I probably should qualify the crash fix a bit. When I first installed 1994, it still crashed. Then I booted to my backup hard drive (C:) and tried it from...
The offset time is related (exponentially) to the tool diameter. If you have a shaft diameter > than the tip/taper diameter then the shaft diameter is used in...
... definition ... I personaly think that no, it wouldn't. It's a pretty obvious workaround without adding options and buttons (IMHO). What I would like to...
I think that a check box would be help prevent operator errors. I prefer to have the tools accurately defined and set the programs parameters to get the tool...
Agreed, if the checkbox is on the tool definition screen, it makes sense. ... prefer to ... to get ... only need ... to open ... screen. ... upgrade ... know...
Anyone else run a picture through 2017??? On two different computers it would sometimes generate a complete toolpath, and most times not. Secondly, It seems...
The image doesn't matter, tried a couple of different ones, However, I fired up Ver. 1789. 5"x3.5" material, default setting of white is Z postive, .1...
I have test days come full,what i must do can test more? dont can testing soft meny veek when i have busy other.but now i have litle time testing more. 2-3...
What do you people use for support material for double sided machining when you're not using the support members? I've seen people using plaster. I've yoused...
Sticky Paws. It leaves not residue on the piece or table. Sticks to just about everything, including carving wax. Pulls up eaisly enought for use on small...
Robert, I haven't done any detailed tests yet but on a few runs I've noticed that the material left after a roughing pass was about twice my specified 1mm in...
Here's one I plan to get: http://www.jlindustrial.com/catalog/product.jsp?origin=SEARCH%3AKEYWORD&id=MTB-10240J I'm still setting up my machines / enclosures,...
Not the first time I read about the mity-bite but the first time I see a somewhat detailed description. However is it reusable? And again, i'd love to hear...
... I've only used it on Plastic sheeting and with blue carving wax for jewelry. I would think that for engraving it would work just fine. My setup was a...
I would guess the ability to reuse the film would be directly proportional to any contamination (transfer) to the surface of the film. Modelers use low melting...
Nice, that's the kind of response i was waiting for. Thanks to everyone else as well though. Anything else than the low melting alloys? i'm guessing wax could ...
... Wax is not a good option. It has poor adhesive qualities and is brittle. Having said that, there are waxes, used for lapidary work, that have a high ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
