I have been a lurker here for a while...I have a question about mic transformers. Why are they so expensive? I have access to a coil winder, how hard would it...
Drive the output of the microphone at low levels from the output of an audio generator with a floating balanced output. The only such generators that I know ...
Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the micbuilders group. File : /Mic...
micbuilders@yahoogrou...
Feb 2, 2006 12:57 am
5028
So looking at the curve you posted, it appears that the impedance would be rated about 500 ohms (assuming you use the vale at 1kHz). Yes ? It is odd how at...
From: Jess Rogers Sent: Thursday, February 02, 2006 00:06 Anyone tried to build your own transformers? It appears to be easy, and it is not difficult to make...
I just saw a pair of Behringer C2's. These are rediculously cheap (like $50 for a pair, including a plastic stereo bar)! They look solidly made too. I...
Hello all I've just messed around with the live recording I made last saturday.. now, if you are corrious how it sounded, you could click this link to download...
Sorry to be late on this thread. Life is like that some times. Why would you think an array of three small capsules would be any worse than a single large...
I built a set of mics with 3 elements per side...two wire mod on WM-61bs... worked out very well. one set was built in a triangle pattern in a pcv cap... Ok...
Hi Rick! ... Because they are rarely used, so the market is small, and because esoteric audio stuff tends to have a price tag that has no sensible relationship...
... Place the mic in front of constant sound source. Look at the output with an oscilloscope, or with a high impedance preamplifier connected to a VU meter or...
I am taking my freq response and noise measurements with an HP3580A spectrum analyzer which provides X-Y plotter outputs (0 to +5V on each output) but NO...
There are some little interface boxes for computer based oscilloscope and data capture, basically A/D converters that can handle DC and higher-than-audio...
From: michael.eaton Sent: Sunday, February 05, 2006 15:32 ... spectrum analyzer which provides X-Y plotter outputs (0 to +5V on each output) but NO digital...
... Very cool stuff. Zap and I have been talking about this already. Take a look at his mic polarizing circuits. My next project is to run a high end...
... ... Any suggestions for reasonably priced software/hardware combo to input > this 2-channel analog data into a computer for graphing and/or ... Hi Mike and...
I'd look for a copy of "Nuts & Volts" magazine - it's a heavy DIY electronics magazine, probably there's an ad or three for something like this cheap. Or a...
I hadn't seen this paper referenced on the board and I thougt it might be of interest to folks, esp. his conclusion re the new circuit model. file in the files...
Thanks to all who have offered suggestions. I also checked into the USB-1208LS from Measurement Computing but their "TracerDAQ" software does not have an X-Y...
From: michael.eaton Sent: Thursday, February 09, 2006 16:01 Thanks to all who have offered suggestions. I also checked into the USB-1208LS from Measurement...
Hi guys, I am going to pull out a channel strip from an old Soundcraft mixer and make a stand-alone microphone preamp. Could you give me some comments on the...
Hi Nick- That design looks good. Remember to check voltages before hooking up the channel strip. I'd put some LEDs in on the output sides of the suply...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
