Hi Jason For my test I had 3 alnico bar magnets around 3", I had two overlaping as the slator and one on a bearing as the rotor, the rotor would attract to the...
Hi. I tested with stacked ferrite blocks on a bicycle wheel. Heavy stuff. And I had the stator in my hand. A mounted stator didn't work. This cannot be seen as...
Hi. Perhaps placing a small NEO now and then at the end of the Alnico will 'reload'? I wonder how it goes with the Gauss meter kit from Darren. I guess I have...
Eric I am impressed by the wheel in your video. It appears that you are able to get about 300 degrees of rotation using angled magnets. Have you tried...
where on the website can this video be seen? [Non-text portions of this message have been removed]...
MILEHIGH3D@...
Sep 1, 2004 11:39 pm
2138
Status: I have my pendulem almost complete so I can finish testing my shielding. After that I can get the rotors cut and finish building the turbine motor. By...
Hello, Mark. I am new to this list, and had some tests done on the Adams motor- generator. Well, electro-mechanical devices are not the specialisation of this...
Hi Peter. I did tests with a device I called 'multi-wheel'. It is in my photobooks on the web-site as well. That didn't work too well but I made it before I...
Eric- I think this is why the Prendev motor uses three rotors. Two wouldn't be enough to counteract the forces involved, but three ensures that there's always...
Eric, why don't you try to shield the front of the second wheel to reduce the repulsion so that it is easier to enter. ... Mark Hayton mark_hayton@... ...
Because I noticed that when the repulsion is less, the final kick is less as well. It's like the spring: squeezing it very much takes energy but the stretching...
Hi Jared. My multi wheel had 3 wheels as well. But I agree: I have to redo the multi wheel experiment now I'm able to build much better wheels. Eric. ... From:...
So, if there always has to be a squeeze force introduced into the system, how would this design ever work? I guess I am missing something.. ... Mark Hayton ...
The pendulem is to test a shielded gate that I am designing for my turbine motor. There is a magnet at the end of the pendulem arm that represents a rotor...
After 5 years of doing tests with different magnet set-up on different wheels I must say that I'm not too happy when I found this out. I hope that I'm missing...
My turbine design, like the Perendev motor, forces the rotor into a constant state of unbalance. Since there is no entering or exiting of a ramp or gate, I...
If you can make a ramp where a roller rolls up a ramp lets say 1 inch and then drops off the end and escapes the sticky spot but is even 1/8 inch higher than...
http://jnaudin.free.fr/html/s102jln.htm Check this one out, this shows them going up and one SMOT launched a ball into the next one.. They look like they are...
Norman, If you think about it you will realize that the ramp challenge has been demonstrated, has anyone repeated this experiment successfully if so the...
Greg Watson made a closed loop as a kit but when he started to receive orders, he disappeared with his device from the Internet. I made a smot with 15 tracks,...
Well after all the other work you have done do you have any second or additional thoughts? One thing about this that has always intreagured me is the ball. It...
Mark I think it is unwise to rule out attracting magnets in a design. I have uploaded two photos (I have no video camera yet) showing the start and end...
I am not ruling out attraction in a design, I just personally don't understand how it would work. Maybe you can show us with your design.. good luck.. ... Mark...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
