Thanks Scott,

I've already tried all the combinations that I can think of. I am
getting nowhere. I have made sure that there is no other driver set to
the Com1 Port and I have set the .ini file to Port 0, 1, or 2. I have
also connected a known good modem to th Com1 Port and it worked just
fine. I later removed the driver for the modem.
I have not seen any documentation as to what the Com Port setting
should be set to (Baud rate/start/stop). Where is that specified?

I there any other way to asses what is going on or where I can get
this thing debugged? Is there a service somewhere?

Thanks,



--- In mrrobot@yahoogroups.com, "Scott Jantz" <scott@...> wrote:
>
> Somehow you are not connecting to the right serial port. When you
download
> the P-code the lights should blink rapidly. Check to make sure you are
> connected to the same serial port you have configured IC to use.
> --Scott
>
> -----Original Message-----
> From: mrrobot@yahoogroups.com [mailto:mrrobot@yahoogroups.com]On Behalf
> Of wrightski1
> Sent: Saturday, March 25, 2006 1:30 AM
> To: mrrobot@yahoogroups.com
> Subject: [mrrobot] Re: Download of Pcode won't initiate
>
>
> D2 blinks ON and OFF whether or not I "OK" the download from ICWIN.
> In other words, I don't see a difference in the blinking from before
> I "OK" the download to after I "OK" the download. I do get a timeout
> error from the IC.
>
> MW
>
>
> --- In mrrobot@yahoogroups.com, "Scott Jantz" <scott@> wrote:
> >
> > Do you get blinking lights during the download? Do you get an
> error from
> > IC?
> > --Scott
> >
> > -----Original Message-----
> > From: mrrobot@yahoogroups.com [mailto:mrrobot@yahoogroups.com]On
> Behalf
> > Of wrightski1
> > Sent: Friday, March 10, 2006 12:24 AM
> > To: mrrobot@yahoogroups.com
> > Subject: [mrrobot] Download of Pcode won't initiate
> >
> >
> > With my TJPRO connected to a PC from Com1 to a MB2325A through the
> > Ribbon Cable, I cannot get the pcode download to start.
> >
> > -The Power Switch is ON, and the Download/Run is in the Download
> position.
> > -D1 is ON and D2 goes ON when I press the Reset. However, when I
> > release the Reset, D2 blinks ON and OFF whether or not I "OK" the
> > download from ICWIN.
> > What might not be working?
> >
> > Also, I cannot find documentation describing the COM settings on the
> > PC. I currently have 8N1 None at 9600 Baud. Is that supposed to
> work?
> >
> > Thanks
> > MW
> >
> >
> >
> >
> >
> >
> > You are getting this e-mail because you subscribed and your
> settings are set
> > to receive a copy of all the messages. You can change your
> preferences to
> > "Web Only" by logging into your account.
> > Yahoo! Groups Links
> >
>
>
>
>
>
>
> You are getting this e-mail because you subscribed and your settings
are set
> to receive a copy of all the messages. You can change your
preferences to
> "Web Only" by logging into your account.
> Yahoo! Groups Links
>