Hi,

I just bought a TJ-Pro and I am having problems loading the initial
code onto the robot. Upon installing the Interactive C freeware and
attempting to follow the instructions for loading the bootstrap code,
etc this is what happens:


I start IC and there is an error message. I connect the robot. The
MB2325 red diode lights up and stays on when I reset the robot in
download mode. I follow the prompt to configure the board and to
select the com port and press Download Pcode. I select the TJ-PRO.ic
file and hit ok. This happens:

Please find the definition file that matches your board type.
Downloading bootstrap code to the board (256 bytes)
Downloading bootstrap code to the board (256 bytes)
Bootstrap load successful.
Downloading the pcode to the board... this may take a while.
Download complete.

The next error message appears telling me to reset the board in run
mode. I do so and click "OK". This happens:

Synchronizing with board
Pcode version 3.10 present on board
Loading C:\ictjp\libs\lib_tjp.lis.
Loading C:\ictjp\libs\lib_rw11.c.
Loading C:\ictjp\libs\twoservo.icb.
Loading C:\ictjp\libs\twoservo.c.
Loading C:\ictjp\libs\motorp.c.
Initializing interrupts
Downloading 1588 bytes (addresses 8000-8633): 1588 loaded
Downloading 101 bytes (addresses 8634-8698): 101 loaded
Downloading 19 bytes (addresses 8699-86AB): 19 loaded
Board synchronization error: sent 98, received 12
errors

An error message appears telling me "Board error. Retry?". If I click
retry the same thing happens:

Initializing interrupts
Downloading 1588 bytes (addresses 8000-8633): 1588 loaded
Downloading 101 bytes (addresses 8634-8698): 101 loaded
Downloading 19 bytes (addresses 8699-86AB): 19 loaded
Board synchronization error: sent 98, received 12
errors

I have no idea what this means and cannot seem to get past this
error, and its always the exact same one. Can anyone tell me how to
resolve this issue?


Thanks in advance