Its a Cisco 7206 Router so the assumption was made to that
effect yes.. and It was an 0x81..



Now it did work, then they upgraded the IOS, could cisco /
the router guys turned off V2c ability ?

Thanks for the response.
Martin


At 09:50 AM 1/29/02 -0500, you wrote:
>Are you certain the box you are polling supports SNMP V2c?
>What was the hex code it was returning before? Here are
>a few of the extended error codes for SNMP V2c:
> 0x80 No such object
> 0x81 No such instance
> 0x82 End of MIB view
>If you were getting 0x80 or 0x81, it would mean that
>the device you are querying doesn't support that
>OID/Instance.
>
>-----Original Message-----
>From: Martin Rheumer [mailto:martinr@...]
>Sent: Tuesday, January 29, 2002 1:03 PM
>To: Dave Sanders; Simon Leinen; Yannis Nikolopoulos
>Cc: mrtg@...
>Subject: [mrtg] Re: polling using SNMP V2c problem
>
>
>
>Simon / Gents.
>
>I upgraded my SNMP_Session and BER.pm to the ones from your site.
>( in the tar ball, latest version ) and still getting the same
>problem trying to use SNMP Version 2.
>
>This time its
-- cut --


--
Unsubscribe mailto:mrtg-request@...?subject=unsubscribe
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi