Helllo I am designing a schematics where the NB address bus and data bus is connected to just one FPGA. So do I still need to buffer the these data and address...
Helllo I am designing a schematics where the NB address bus and data bus is connected to just one FPGA. So do I still need to buffer the these data and address...
I tried to post it here before but didnt get any response. If I just have one device connected to netburner, then do I need to buffer the address and data...
How do I set the time zone used by the Netburner's Real Time Clock? I'm using a MOD5282. This code outputs the zone "GMT", but I would like to be able to set...
... I'm using a MOD5282. This code outputs the zone "GMT", but I would like to be able to set the RTC to another time zone, and output the time for that zone....
Hi, Thanks, but that's not what I want to do. I can already set the time to whatever time I want. I just want to use the built-in time zone variable (if there...
Dan: You will have to code what you want, I believe. There is no "time subsystem" in the NB code library. There is only an RTC that is initially set to some...
... initially ... GNU C has some built-in functionality here... I occasionally modify the environment variable that sets timezones. You can do this by the...
I just downloaded and installed version 2.2 rc3 of the Development Kit. When I try to compile one of the sample programs that was included with my MOD5213, I...
Thanks a lot! That's exactly what I needed to know. Dan ... netburner_group@yahoogroups.com , "chris ruff" <cgruff@...> ... "time ... initially ... ...
There shouldn't be as I've not edited it. The only thing that should be there is what the installer put it. I did forget to mention that the NNDK was...
You'll need to buffer / latch the lines. Info should be found in the hardware reference of the chip. ________________________________ From: Shahabuddin Inamdar...
For my own use I've built a PK70 blade board with the following: 16 Channels of 12 bit A/D using 2 of the MAX197 A/D 4 optically isolated power switches the...
We have stopped really monitoring this forum it is currently overrun with SPAM. Our active forums are at: http://forum.embeddedethernet.com/viewforum.php?f=1...
#1 VoIP Business Phone Service Provider * Unlimited Local & Long Distance * New or Keep Your Existing Number * Auto Attendant included FREE * 25 Advanced...
Has anybody try to connect an slow LCD Display (10MHz) with a MOD5234 device? Any recommendations? I'm having some problems with basic write bus cycle timing? ...
Hi, The use of these lines varies depending on what you are doing. Is this for a new processor board design? If so, what type of flash and ram are you using? ...
Hi E.Patterson, I have receive the answer form Netburner. "The /RCON signal pin is tied to ground with a 4.7-kOhm resistor, and both CLKMOD0 and CLKMOD1 are...
3 Steps will change your life 1- Join Memolink For Free Becoming a Memolink member is simple and takes less than a minute. 2- Earn Points Earn points for...
Hi, I have a question regarding the Netburner's MOD5270 GPIO. I made one of the digital I/O pin to be an input, but I can see a voltage of 3.3V at the pin. Is...
Hello there. I have few questions about MOD 5234. I am using MOD5234 to program my FPGA. For this, I generate the PROGRAM PULSE so that the configuration...
Hello, The 5-6 second delay from power up to the start of execution of your code is the time the NB monitor program is running. It waits 5 seconds to give you...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
