*************CORRECTION*******************

Robot Recipes (the document posted at
http://www.chiefdelphi.com/media/papers/2029 contains a rather major error
(aargh!).

For the Chin-upbot, (project #2), under "Parts to cut", the instructions for
cutting of angle bars are wrong.

The INCORRECT version currently reads:
Cut 3 X 15” angle bars into 2.5” + 12.5” (on the notch) – only the 2.5” pieces
are used
Cut 1 X 15” angle bar into 5” + 10” (on the notch) – only the 10” piece is used



The CORRECT version should read:

Cut 3 X 15" angle bars into 5" + 10" (on the notch) - only the 5" pieces are
used

From one of the remaining 10" pieces, cut one 7.5" piece (on the notch -- this
is the center section)



My apologies -- I hope the error doesn't cause too much frustration & wasted
metal. In our eagerness to start on the Challenge, we were a bit hasty in
wrapping up this project.



Yolande

_____________________________________________________________
Handyman Franchises. Click Here.
http://thirdpartyoffers.juno.com/TGL2111/fc/Ioyw6iigg6DCT9JFBdeTPtp5mSTadrkjlbpn\
srKX6OpvrqaMRdVGEB/