I'm running Debian and i've tried to add the 3 extra USB ports however only R160/R161 works and shows up as usb 2-2 R163/R164 shows [42949400.470000] usb 3-2:...
I'm running Debian and I've tried to add the 3 extra USB ports, however only the one connected to R160/R161 works and shows up as usb 2-2. When I plug into...
I know the nslu2 has a 100mb connection. I guess it would be difficult to hack it and add a gigabit connection. Then again, wouldn't using a Gigabit to usb...
... The NSLU2 doesn't have what it takes to drive a Gb network connection with any firmware of which I'm aware. You would do better by finding something with...
Hi, It's several days ago when I first noticed this problem, but I haven't seen any warning anywhere so it's time to notify the list. If you run ipkg update it...
so I have an NSLU2 that was previously flashed - I am not sure WHICH one it is however (I have more than one) - it is either a debian flash, or I believe...
Hi Look into the file /opt/etc/cups/printers.conf. At the bottom you will probably see "ErrorPolicy stop-printer". This causes cups to set the printer in a ...
Do you think it's possible to use nslu2 as a capture the flag web application server? I need php and MySQL support for that and quite some concurrent threads. ...
Hi, I would very much like to see this project working with Ruby on Rails and Redmine. Is someone still active with this project? Please let me know. Thanks....
Hi all I have a share (/routers) configured on my NSLU2 (unslung firmware), and I have a user setup to access that share. I have two routers (DD-WRT) which...
... I'm not even sure to which web site you refer. The wiki has certainly been updated. But in any case, developers remain active; optware in particular is...
I have been dealing with an issue where my nslu2 will not boot and will also not go in to upgrade mode via the reset button. So I finally figured out how to...
... Do you have the serial console mod on your NSLU2? Sounds like the same symptoms that happen when the serial cable is un-terminated, and reflects the...
Hi. I'm considering moving from unSlung6.8 to Debian. It seems a bit of a palaver getting the slug into RedBoot on a dedicated network segment and then using...
Hi there, I've problems with the speed rate on the NSLU2. I have attached both an usb-stick and an external HDD to the USB-ports. Transfer rates for the...
... Make the block size (bs) a multiple of the physical sector size of the disk. (multiple of 512) Otherwise, you are probably reading one (1000-byte) block...
... NSLU:~# dd if=/dev/sdb1 of=/dev/null bs=1024 count=1000 1000+0 records in 1000+0 records out 1024000 bytes (1.0 MB) copied, 1.70798 s, 600 kB/s I suppose...
Is it just me or are there problems with the IPKG repository? If I use ... then the command works fine and package information is downloaded However, if I then...
Thanks Brian. It's the same one that I've been using for the last few years. In fact, I don't recall ever manually configuring a URL for IPKG. Anyway, when I...
Thanks Brian, and apologies for managing to confuse things with my initial comments. ipkg update is working fine and downloads stuff, but then ipkg upgrade...
