I want to replace the 'system' disk (the one to which I have unslung) by a larger one. It is connected as 'Disk1'. Can this be done without re-installing...
Hi Frank, ... Have a look at: http://www.nslu2-linux.org/wiki/HowTo/SwapDrivesOnUnslung I have added a seccond methode with a file copy as well there. -- ...
... No, it does not work with 6.10 - it panics the kernel. A quick google of the insmod messages above reveals that this message occurs when the kernel has not...
Hi folks, My NSLU2 was working fine with a Trekstor Disk attached ( in fact it is a WD drive. The Spindown of the drive was managed with a spindown script...
Hi to all! After updating my slug with aptitude i have had this problem with amule. Starting the amuled daemon with : /etc/init.d/amule-daemon start this is...
Thank you Mike, for your fast answer. But i went faster, shame on me. I installed Unslug 6.10 and I had what you describe. SLUG freeze when i make the "insmod...
... Hi, I do see the same messages on my NSLU2 running uNSLUng 6.8 beta It does raise concerns but actually I do not experience any issue so far. I assume that...
... Well... just for the record XP is just as complicated, and even more difficult if you need to get anything but Microsoft's vision of TCP/IP is working....
... The source for that driver is proprietary, and is not available. There is an opensource driver (two actually) available in the 2.6 kernels, but Unslung...
Hi All, After following the article at http://www.nslu2-linux.org/wiki/HowTo/SwapDrivesOnUnslung I have replaced my 1gig boot device with a 250gb Maxtor SATA...
... http://www.nslu2-linux.org/wiki/FAQ/DealWithAutoSpinDownOnSeagateFreeAge\ ... I had the same behavior with a seagate drive (aka Maxtor) on an Ubuntu system...
... I observed the same when I put an EXT3 formatted disk in on port 2 after unslinging to port 1. There are warning notes of badness/oddness happening when...
Hello, Can someone advise a simple backup solution for the slug. Now that I have things setup as I want them I need to backup the whole system in one easy...
Hi folks I have two slugs: slug1 has been running uNSLUng for about 9 months with 2 300GB drives, Samba-ed out for backup and media storage across my home...
Hi, I am trying to get a perl script to run but do not know how to install the additional libraries. The readme for the file states: - Perl 5.6+ ftpsync.pl was...
Hi Jon, I saw something very similar with SlugOS/BE 4.9 and SlugOS/LE(EABI) 4.9 which right now makes my slug pretty much unusable as a file server. You can...
... Is the 250 GB disk a "native" formated disk or a full ext3 disk? The linksys software does a lot of magic in mounting and sharing the devices. But...
I too would be very interested in any more information that can be found about these situations. I've been quite unable to duplicate Thomas' issue with SlugOS...
... found ... Thanks for the replies Mike & Thomas. I remember your conversations last month & decided they didn't apply to me because they were with 4.9 &...
... Hi, I am not sure, but wont any solution of backing up single files from Linux to Windows cause permissions problems? I actually use my slug to backup all...
Hello, I tried under SlugOS BE from the wiki: http://www.nslu2-linux.org/wiki/Optware/Haserl Haserl is a small program that uses shell or Lua script to create ...
Sorry if this is a stupid question, but I don't understand the mounting of file systems. I've unslung (6.8 beta) to disk 1. Connecting only disk 1 gives this: ...
... I'm not experiencing your issues but might I suggest a couple of things to try? Have you tried copying with SSH? It will checksum the data as it goes. If...
... To backup to a Windows machine without loosing permissions, use "tar -czvf " then copy the file to the Windows box with Samba. If you don't have enough...
